1. FILL TANK WITH FRESH WATER
Add 10 Litres of fresh water to the fresh water
tank. Add CAMP RINSE detergent
2. OPEN SLIDE VALVE (FLUSH VALVE)
As a change in pressure and temperature
may cause pressure build up in the waste
tank, press the exhaust valve button before
pulling out the slide valve
3. OPEN THE SEAT COVER
4. LIFT AND PRESS FLUSH PUMP
The capacity of the fresh water tank provides up
to 60 flushes. Twin nozzles provide a better and
more efficient clean
5. CLOSE SLIDE VALVE
The level of the waste tank can be seen through
the colour gauge located on the front side of the
waste holding tank
CAUTION
•Place on flat and level surface
•Ensure all latches are locked
•Ensure the Waste Holding Tank is assembled correctly and cap is
screwed on securely
•Bearing weight limit is no more than 200kg
•Do not lean on the seat cover
•Do not disassemble the Piston Pump
COMPONENTS
1. Seat Cover
2. Seat
3. Piston Pump
4. Cap For Fresh Water Holding Tank
5. Fresh Water Holding Tank
6. Latch Assembly
7. Waste Holding Tank Cap
8. Waste Holding Tank
9. Water Level Indicator
10. Slide Valve Assembly
11. Air Release Button
LATCH OPERATION
TO OPEN
Pull Out Top Press
Downwards
Separate Latch
With Tank
TO CLOSE
Open Latch Place in
Groove
Puch Top
Into Position
Empty Half Full Full
