Zest 4 Leisure Lily Double Relax Seat User manual

Assembly Instructions
(W x D x H) 1.75m x 0.92m x 0.92m
Product Name: Lily Double Relax Seat
PLEASE KEEP THIS INSTRUCTION
Zest4Leisure
01352 752555 option 1 –[e-mail]

Lily Double Relax Seat Assembly Instructions
Requires 2 person assembly.All screw holes to be pre-drilled.
Tools required: Corded / Cordless Drill, Pozi-drive Bit / Screwdriver, 3mm Drill Bit.
Lily Double Relax Seat Pack List
Item Description Quantity
A Back SupportAssembly 1
B SeatAssembly 1
C BackAssembly 1
D1/D2 Armrest/LegAssembly 2
E Leg 2
F Upper ShelfAssembly 1
G Lower ShelfAssembly 1
Fixings
50mm Screws 18
Hex Bolts 12
‘T’ Nuts 12
Hex Screws 4
www.zest4leisure.co.uk

Please take a few moments to check all pack contents listed.
Please contact “Zest4Leisure” directly if any of the pack contents are damaged
or missing. Contact telephone: [phone] option 1 or email:
[email protected]
Assembly requires 2 persons. All screw holes to be pre-drilled.
Tools required: Corded/Cordless Drill, Pozi-drive Bit/Screwdriver, 3mm Drill Bit.
Lily Double Relax Seat is now complete.
1. Insert Back AssemblyA between rear legs of SeatAssembly B, align bolt holes
and insert 2no Hex Bolts and ‘T’ Nuts. See Figs. 1a, 1b & 1c.
Do not fully tighten at this stage.
2. Locate Back Assembly C as shown in Fig 2a and fix in position using 6no Screws.
See Figs 2b & 2c.
3. Position Armrest/Leg Assembly D1 as shown in Fig.3a. Align bolt holes and insert
2no Hex Bolts and ‘T’ Nuts. See Fig. 3b. Do not fully tighten.
Attach Armrest/Leg Assembly D1 to Back Support Assembly A using 1no Screw.
See Fig.3c.
Repeat stages 1-3 for remaining seat using Armrest/Leg Assembly D2.
4. Position Leg E as shown in Fig.4a and attach to Upper Shelf Assembly F using
1no. Screw. Fix remaining Leg E in corresponding position on Upper Shelf
Assembly.
Ensuring correct orientation of Lower Shelf Assembly G, attach to both Legs E
using 2no. Hex Screws. See Fig.4b.
5. Place shelf assembly between seat assemblies (D1 & D2 outermost) Fig.5a,
locate screw/bolt holes and attach using 4no. Hex Bolts & ‘T’ Nuts to front
(Fig.5b) and 2no Hex Screws to rear (Fig.5c).
Attach rear of Upper Shelf Assembly F to Back Support AssembliesA using 2no
Screws as shown in Fig.5d.
Fully tighten all bolts at this stage.

www.zest4leisure.co.uk
1b1a
1c 2a
2b 2c
3a 3b

www.zest4leisure.co.uk
3c 4a
5a4b
5b 5c
5d