3
Dot pitch (Vertical) 0.125 mm (8 dots/mm) line feed pitch
Effective Printing area 72mm
Number of Columns ANK 48 columns/line (maximum 12x24 dot font)
Paper width 80mm
Paper thickness 60 to 100 um: some paper in this range may not be used because of
paper characteristics
Printing Speed Maximum 80mm/sec (640 dot line/sec)
Character type Alphanumeric, kana: 159 types
International characters: 195 types
JIS Kanji (Kanji CG loaded board: about 6800types
Character, dimensions
(WxH), number of columns 12x24 dots, (1.5x3.0mm), 48 columns:ANK
24x24 dots, (3.0x3.0mm), 24 columns: ANK
8x16 dots, (1.0x2.0mm), 72 columns:ANK
16x16 dots (2.0x2.0mm), 36 columns: ANK
Interface Conforms to RS232C / Centronics/USB
Dimensions 112 x 116.5 x 59.5mm (WxLxH)
Weight 470g (with battery)
Head Pulse resistance: 50 million pulses/dot (under our
standard conditions);
Abrasion resistance: paper travelling distance
50km (print ratio: 12.5% or less)
Life
Cutter 500,000 cuts
Operating
temperature* 0°C to 50°C
Operating humidity 20 to 85% RH (no condensation)
Storage
temperature ~20 to 60°C (paper not included)
Operating Environment
Storage humidity 5 to 95% RH ( no condensation)
Head temperature
detection Detected by thermistor
Paper out/mark
detection Detected by photo-interrupter
Detection
Platen release Detected by sliding switch
High Sensitive Paper TF50KS-E4 (Nippon paper)
Standard paper: TF60KS-E (Nippon paper),
FTP-020PU001 (58mm), PD105R (Oji Paper), FTP-020P0701 (58mm)
Long Life Paper PD160R-N (Oji Paper)
AFB-235 (Mitsubishi Paper), TP50KJ-R (Nippon Paper), HA220AA
(Nippon Paper)
Recommended thermal
sensitive paper
Medium Life Paper TF60KS-F1, FTP-020P0102 (58mm), PD17OR (Oji
Paper), P220VBB-1Mitsubishi Paper)
RAM 256K (MAX:4M flash&SRAM)
Remark: All contents are subject to change without notice.
3. Operation Guide
3.1. Loading Paper Roll and Placing the Battery
(1) Open the top cover then lift up the paper compartment.
(2) Place the paper roll in the compartment and make sure it is aligned to fit
inside.
(3) Pull the leading edge of the paper roll straight to pass over the paper
cutter. Close the top cover.
(4) Place the battery according to the + & - markings.
(5) Push the battery rightward to the end.
(6) Close the battery cover and tighten screw to lock it.
