Zico QUIC-RELEASE QR-D-S Parts list manual

ZICO®
3030PM24
QUIC-RELEASE®SLIdE-OUt CyLIndER BRACkEt
MOdEL QR-d-S
PARtS And InStRUCtIOn MAnUAL
MODEL DESCRIPTION WT./@ IN LBS.
QR-D-S Slide-Out Cylinder Bracket 1.7

Page 2
Parts Breakdown
ITEM
NO. PART NO. DESCRIPTION QTY.
1 3030-102-101 STOP BLOCK 1
2 3030-102-103 SPRING 1
3 3030-102-105 STOP PLATE 1
4 3030-102-107 HOLDER, D CYLINDER 1
5 9180-002526 CLEVIS PIN, 1/4" x 1-5/8" 1
6 9140-111218 SPRING PIN, 1/8" x 1-1/8" 1
7 3030-102-901 STRAPASSEMBLY 1
8 9260-001802 RIVET, 3/16" x .188/.250 4
9 9114-101800 WASHER, #10 4
10 9070-000612 COTTER PIN, 1/16" x 3/4" 1
11 9114-112500 WASHER, 1/4" FLAT, SS 1
12 3030-102-111 LABEL, MODEL QR-D-S 1
13 3030-112-117 LABEL, OXYGEN 1

Ziamatic Corp.
10 West College Avenue, P.O. Box 337, Yardley, PA 19067-0587 • [phone] • FAX: [phone]
*ZICO is a registered trademark for re, safety and marine products made by Ziamatic Corp.Copyright Ziamatic Corp. 2-17
www.ziamatic.com
TOLL FREE: 800-711-3473
Page 3
Operating Instructions
To store standard and steel "D" cylinders:
 1. Slidecylinderintobracketbottom-rstuntilitclickspasttheStopBlock(1).
 2. CheckthatthecylinderisnowsecureagainsttheStopBlock.
To remove cylinders:
 1. PullrmlyonStrapAssembly(7)toreleaseStopBlock(1).
 2. WithStopBlockinthereleasedpositionpullcylinderfree.
Mounting Instructions
To attach QR-D-S to cot using straps:
 Important:ThereareslotsintheHolder(4)sothattheQR-D-Scanbeattachedtotheframe
 workofanambulancecotbymeansofstraps.BeforepermanentlyattachingtheQR-D-S,
 makesurethatitdoesnotpreventthecotfromproperlycollapsingduringnormaloperation.
To attach QR-D-S to a at surface using fasteners:
 Selecthardwarethatwillnotscratchthecylinder.
 Mountusingaminimumofeitherfour#10orthree1/4"hardware.
 Useatwashersbetweentheholder(4)andthefastenerhead.