Repeat the process for the month and day.
-Setting the location
After the date is set press the up arrow to show the Location menu.
Use the up/down arrows to select your state and press SET to confirm the selection.
Use the up/down arrows to select your city and press SET to confirm the selection.
Latitude/Longitude Setting
Important : This is only needed if your city state is not on the list.
1) If your state or corresponding city is not on the list, continue scrolling
using the arrows until Lat/Long is highlighted.
2) Press the SET button to enter Latitude/Longitude menu
3) Use the Up/Down arrows to set the value of the highlighted digit of your
Latitude.
4) Press Menu/Set to move to the next digit.
5) Repeat steps 3 and 4 until latitude has been entered to two decimal places.
6) Press Menu/Set to save your latitude and move on to longitude.
7) Use the Up/Down arrows to set the value of the highlighted digit of your
Longitude.
8) Press Menu/Set to move to the next digit.
9) Repeat steps 7 and 8 until longitude has been entered to two decimal places.
10) Press Menu/Set to save your longitude.
Note: The flashing red LED will stop. Your required setup fields are complete.
You will now return to the Home screen
Setting the Cycle Time:
Important: The cycle times set how long you refrigerator stays off on Shabbos and Yom Tov vs. how long the refrigerator stays
on.
We recommend testing each preset mode during the week for a minimum of 24 hours to see which works best for you and
your refrigerator. During the 24 hour test period, monitor the food in refrigerator and freezer to determine which cycle works
best.
Total cycle time (on and off)
Note: All cycles start at the
top of the hour in order to
give access at the
beginning of each quarter
hour or half hour
throughout Shabbos and
Yom Tov.
7:30 minutes
(2x in 15:00 min)
Once the correct information is set, the Smart Control will automatically activate Shabbos/Yom Tov Operation each week.
*CAUTION: Before pushing
the refrigerator back into
place; be sure to use the
feature to lock the device and
to prevent accidental changes
to the settings.
In the Setup menu choose
- On.
The PIN for every device is
9-1-9-1. The PIN cannot be
changed.
