Zotac ZBOX series User manual

QUICK START GUIDE
PACKAGE CONTENTS
CUSTOMIZING YOUR ZOTAC ZBOX
INSTALLING MEMORY MODULES
INSTALLING A HARD DISK
• 1 x ZOTAC ZBOX
• 1 x Stand
• 1 x VESA mount
• 1 x AC Adapter
• 1 x Power Cord
• 1 x Warranty Card
• 1 x User Manual
• 1 x Driver disc
• 1 x USB drive with O/S driver
• 1 x Antenna
1. Lay the ZOTAC ZBOX on a flat surface with the rubber
feet facing upwards.
2. Locate the two thumb screws and remove.
3. Slide the cover o the ZOTAC ZBOX in the direction of
the arrow.
1. Locate the SO-DIMM memory slots and insert a SO-DIMM
memory module into the slot at a 45 degree angle.
(Note: If the ZOTAC ZBOX has two SO-DIMM slots insert a module
into the lower slot first)
2. Gently press down on the memory module until it locks
into place by the arms of the memory slot.
1. Locate the 2.5-inch SATA hard disk and the hard disk
bracket.
2. Install the hard disk to the hard disk bracket.
3. Insert the hard disk into the slot at a 45 degree angle
and gently slide into the connector.
4. Reinstall the thumb screw.
1
2
3
2
1
2
1
34

SETTING UP YOUR ZOTAC ZBOX
FRONT PANEL
1. Select your ZOTAC ZBOX position
i. Place ZOTAC ZBOX sideways
ii. Install ZOTAC ZBOX on the stand
iii. Mount ZOTAC ZBOX to a monitor
2. Connect antenna for WiFi
3. Connect to a home network
4. Connect USB 3.0 devices
5. Connect a DisplayPort display
6. Connect an HDMI display
7. Connect power cable
8. Turn on the system
9. Install operating system
1. Headphone/Audio Out jack
2. Microphone jack
3. USB 3.1 port / Memory card reader
(SD/SDHC/SDXC)
4. USB 3.1 Type-C
5. WiFi LED
6. Hard drive LED
7. IR Receiver
8. Power button
REAR PANEL
1. WiFi antenna connector
2. LAN (RJ45) ports
3. USB 3.0 ports
4. DisplayPorts
5. HDMI port
6. Power input (DC19V)
1 2 3 4 5 6 78
1 2 3
456
4
2
3457
8
6
iii
ii
i
1