Page 3 © Zovuna
Installation Steps
Check arm width of your chair or
sofa to determine the
configuration needed.
If width is between 1 & 2.5 inches
go to step 2a.
If width is between 3 & 7 inches go
to step 2b.
If the chair arm width is between 1 & 2.5
inches you will need to reconfigure the
adjustable arm. This is done by removing
the screws and reversing the adjustable
arm as shown.
If the chair arm width is between 3 & 7
inches the standard configuration can be
used. Loosen screws so that adjustable
arm moves easily.
Slide table down on chair arm and move
adjustable arm so that it’s snug to chair
arm. Then tighten screws.
If using the slot cover it should be pressed
into slot. Both ends should click into
place.
Note: Slot cover may not fit in cases where
screws are positioned near end of counter
sunk slot. There must be clearance on
both ends of the slot to use the slot cover.
If using the non-slip pad simply place on
table while aligning the protruding bar on
the pad to the slot on the table. This will
align is perfectly with the table.
