ZQRACING Hero series User manual

ZQ RACING GAMING
OFFICE CHAIR
ASSEMBLY INSTRUCTION
Safety Information: the maximum load/limit of the chair is 150kg. Please
follow the following step-by-step instructions while you assemble your new
chair, we are not responsible for damage if these instructions are not
carefully followed.
ZQRACING WARRANTY
All ZQRacing chairs structures (steel frames) come with life time warranty.
All other parts come with a 2 year warranty (excluding natural wear of fabric:
eg. PU leather and Vinyl). Please retain your prove of purchase for warranty
purpose. For details, please visit http://www.zqracing.com.au/terms-and-
conditions/
PARTS SERVICE:
We offer lifetime support in case of expired or non-warranty issues, which
you can buy replacement parts of your chair at a fraction of a new chair
cost. Please contact us for detail.
Pictures are for demonstration only and may differ from your actual chair in
appearance and features.
ZQRACING
ZQ PTY LTD
11/37 Mortimer Rd
Acaicia Ridge, QLD 4110
www.zqracing.com.au
[e-mail]
Main Box Contents
1.Lumbar support cushion 2.Head pillow 3.Head pillow elastic strips connector
4.Control mechanism 5.Backrest 6.Wheels
7.Hex key tool 8.Star base 9.Telescoping cover
10.Gas lift cylinder 11.Side covers 12.spare screw
13.Seat base
123
4
5
67
8
910 11
12
13

Website : http://www.zqracing.com.au
How to Assemble
Remove the pre-assembled screws and washers
from the backrest.
Remove the protective covers from the brackets of
the seat base.Then position the backrest carefully
between the brackets
Insert and tighten all 4 screws(2 at each side) you
prepared in step 1 by hand first.Then use the tool.
Start with the two screws on the top of each side,
then tighten the bottomscrews.
Position the side cover with the screws aiming at
the sockets.Push the side cover tight with a slight
amount of pressure.
Repeat previous step on the other side. Now place the backrest all the way to the back p-
osition. Flip the complete chair over, facing down.
Then remove the 4 pre-mounted screws from the
underside along with the washers.
Place the control mechanism straight and tighten
the screws from the last step with the tool.The h-
ole to mount gas lift cylinder must face the front of
the seat.
Place the gas lift cylinder with the telescoping cover
into the hole at the base of the control mechanism.
One by one, insert the wheels into the base.Then
place the base onto the cylinder and firmly press
into place.
Now turn the chair over into the upright position.
You may p lac e th e he ad p ill ow ove r the b ac kr est
using the elastic strip and plastic connector pro-
vided.
Insert the straps of the lumbar support cushion thru
the slot at the base of the chair.Take the other ends
of the straps and insert them through the large“belt”
openings of the backrest.Now bring the ends toge-
ther and snap into place.
All Rights Reserved ZQ PTY LTD 11/37 Mortimer Road Acacia Ridge Queensland Australia [email protected] 07 3373 8841