ZyXEL Communications G-210H User manual

Copyright © 2007. All rights reserved
G-210H
802.11b/g Wireless USB Adapter
Quick Start Guide
Version 1.00
3/2007
Edition 1
CONTENTS
ENGLISH 1
DEUTSCH 21
ESPAÑOL 43
FRANÇAIS 63
ITALIANO 83
РУССКИЙ 103
SVENSKA 125

ENGLISH
1
Overview
The G-210H is a wireless network USB adapter for your
computer. See page 19 for a list of system requirements.
1 Install the Software
"If you have already installed Funk Odyssey
Client software on the computer, uninstall
(remove) it.
Install the software from the CD before you
insert the G-210H. Do not insert the G-210H yet.
1.1 Windows
1Remove the G-210H if you already inserted it.
2Insert the included CD into the CD-ROM drive on your
computer.
ENGLISH

2
ENGLISH
3When the following screen displays, click Setup to install
the ZyXEL utility and driver.
VIf the screen does not display, locate and
double-click autorun.exe on the CD.

ENGLISH
3
4In Windows Vista, when the following screen displays,
click Allow to continue.
5In Windows 2000/XP/Vista, select your preferred
language and click Next.
6The following screen displays. Click Next.

4
ENGLISH
7In Windows Vista, if the following screen displays, click
Install this driver software anyway.
8In Windows 2000/XP, select Driver and Utility to install
both ZyXEL utility and driver on your computer. If you
want to install the driver only and use Wireless Zero
Configuration (WZC) with Windows XP, select Driver only
(see Note for Windows XP Users). Click Next to accept the
default file location or click Browse to select an alternate
folder.

ENGLISH
5
"At the time of writing, you cannot use the ZyXEL
utility in Windows Vista. You must use WLAN
AutoConfig to configure the G-210H and
connect to a wireless network. See Windows
WLAN Configuration Tool.
9In Windows 2000/XP/Vista, when the following screen
displays, click Finish to complete the software installation.

6
ENGLISH
1.2 Macintosh
Screen shots for Macintosh 10.4 are shown in the following
procedure unless otherwise specified. The screens on your
computer may differ slightly from the screens shown here
depending on the version of your operating system.
1Close all programs and applications.
2Insert the included CD into the CD-ROM drive. An icon for
the CD appears.
3Double-click the CD's icon.
4Double-click the Mac Driver folder.

ENGLISH
7
5Double-click the .dmg file.
6Double-click your Macintosh OS’s driver folder. The
.command and .pkg files will be created.

8
ENGLISH
7Double-click the .pkg file to install the driver.
8A welcome screen appears. Click Continue.

ENGLISH
9
9You will then see the Select a Destination screen, select a
destination (this must be on an actual physical hard drive
on the Macintosh, not a virtual drive) and click Continue.
10Click Install.
11In Mac OS 10.3, you then see a screen telling you that
you must restart the computer after the installation