ZyXEL Communications RPS300 Manual

Quick Start Guide
www.zyxel.com
RPS300/RPS600-HP
Redundant Power Supply
Version 1.00
Edition 1, 05/2013
Copyright © 2013 ZyXEL Communications Corporation
Hardware Installation Guide

Power Module Hardware Installation Guide2
IMPORTANT!
READ CAREFULLY BEFORE USE.
KEEP THIS GUIDE FOR FUTURE REFERENCE.
This guide shows how to install the power module in the Switch. Graphics in this book may differ
slightly from your product. Every effort has been made to ensure that the information in this
manual is accurate.
Related Documentation
• Rack Mounting Hardware Installation Guide
This guide shows you how to use the rack mounting kit to install the Switch in a rack.
• Fan Module Hardware Installation Guide
This guide shows you how to install the fan module in the Switch.
•User’sGuide
This guide shows how to use the Web Configurator to configure the Switch.
• CLI Reference Guide
This guide explains how to use the Command-Line Interface (CLI) to configure the Switch.
• Web Configurator Online Help
Click the help icon in any web configurator screen for help in configuring that screen and
supplementary information.

Power Module Hardware Installation Guide 3
CHAPTER 1
Power Module Installation
1.1 Overview
Although all modules are hot-swappable, it is recommended you disconnect power or make sure
you are safely grounded and dry before installing or removing power modules.
There is one power module installed in the first power slot of the Switch by default. This section
shows you how to install a second power module or remove the power module.
1.1.1 Installing a Power Module
Use the following procedure to install a power module in the Switch.
1Use a screwdriver to loosen the screws on a power slot cover and remove it.
2Grab the handle of the front panel of a power module with one hand and place the other hand under
it to support it.

Chapter 1 Power Module Installation
Power Module Hardware Installation Guide
4
3Insert the power module into the slot.
4Slide the power module into the slot until it makes contact with the backplane and tighten the
screws.

Chapter 1 Power Module Installation
Power Module Hardware Installation Guide 5
1.1.2 Removing a Power Module
Use the following procedure to remove a power module from the Switch.
1Disconnect the power before you begin.
2Use a screwdriver to loosen the screws on the front panel of the power module.
3Grab the handle and slide the power module out.
4Use a screwdriver and screws to put the power slot cover back.
1.1.3 Power Module LEDs
The following table describes the power module LED.
Table 1 Power Module LEDs
LED COLOR STATUS DESCRIPTION
AC OK Green On The module is functioning normally.
Off The power is off or the module is not ready or malfunctioning.

Chapter 1 Power Module Installation
Power Module Hardware Installation Guide
6