1UP USA Sportube Bracket 1 Series User manual

1UP USA SPORTUBE BRACKET
SERIES 1 & SERIES 2
Parts List
1) U-Bracket Assembly 4) 5/16-18 Fastener
2) Post Assembly 5) Post Lock
3) Bottom Clamp 6) Tensioning Handle
In The Box:
•Two SporTube Brackets
•Hardware Bag

April 17 2
Installation Instructions
Step 1:
•Position the Post Assembly so the two 5/16-18 Fasteners are on each side of the Cross Bars
•Using the included Allen key, tighten the Bottom Clamp and Post Assembly together
oBe sure that the metal side faces down
•Repeat the procedure for the other SporTube Bracket
Step 2:
•Position the SporTube on the Cross Bars so it is tight against the Post Assembly
•The front Post Assembly must fall between the two handles of the SporTube

April 17 3
Step 3:
•Slide the U-Bracket Assembly onto Post Assembly.
Step 4:
•Slide Post Lock through the holes found on the Post Assembly and U-Bracket Assembly and
tighten Post Lock into place.
•Using Tensioning Handle, tighten U-Bracket Assembly down over the SporTube.
•Repeat same process with provided Cotter Pin on second SporTube Bracket.

April 17 4
Together, we’ll do epic things.
Removal Instructions
•Loosen the Tensioning Handle on both SporTube Brackets and remove Post Lock and Cotter Pin.
•Take U-Bracket Assembly off Post Assembly.
•Remove SporTube and store U-Brackets, Cotter Pin, and Post Lock in a safe place.
Additional Instructions:
•Periodically tighten 5/16-18 Fasteners and L-Handle to ensure security of SporTube and
SporTube Bracket.
•Remove U Bracket when not in use.
•Do not use a Series 2 SporTube Bracket on Series 1 SporTube.
Manufactured by:
1up USA.com LLC | 1005 Commerical Drive | Dickeyville, WI 53808
Ph 608.568.7261 | [e-mail]
Questions or comments? Contact our support team via email at [e-mail]