2Y-LINK PF150A12D User manual

1
High Power Model
User Guide
 Power, video and control data are all transmitted between the
Signal Processor and Mixer through the same single pair of
wires, no separate wiring for RS485 data transmission
 Transmission distance up to 5 m
 For cameras of power rating up to 15 mA
 Push-Fit terminals for easy wiring with bell/speaker/UTP cable
 No polarity restriction
 Built-in ground loop isolation feature
1: Video Input (BNC Female plug)
2: R 485 (output, Push Fit Terminals)
3: Power to Camera
(Push Fit Terminals)
4: Power tabilizer Terminal
5: 2-Wire to ignal Processor
Video & Power (Push Fit Terminals)
6: Power LED Indicator
User Guide
Features
Overview
Push Fit Mixer
PF150A12D

2
Connect with CI- 1-ASP-DI & PF15 A12D as shown in this diagram
Connection Diagram
Wiring Notes

3
• The following table shows the necessary wire gauge for twin bell
wire over the expected length between camera and TV Monitor.
Notes :
1. For cameras with operation current up to 1 mA and transient peak current up to
15 mA, also a PS-1 KU power stabilizer is normally required.
2. For camera power over 18W and/or covering extended distances, local power supply
for camera is required and dummy loading 15 R/3W is required for `DC out` in
PF15 A12D
Video Input : 1Vp-p 75-ohm
Power Supply : 48VDC .Max
Operating temperature : -1 °C ~ + 5 °C
Dimensions : 35mm x 58mm x 86mm
Suitable for any Camera with following specification:
Each Camera Rating : 12VDC, 15 mA. Max.
Each Camera Video output : 1Vp-p 75-ohm
≤ 500mA ≤
≤≤
≤680mA ≤
≤≤
≤1000mA
PF150A12D PF150A12D PF150A12D
AWG20
≤ 4 m ≤ 2 m ≤ 1 m
CAT5
≤ 2 m ≤ 1 m ≤ 5 m
Specification
PT
-