3 Star 3S-31 User manual
3S
Instruction Sheet For:
www.VWDULQF.com
Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount. Note: It is highly recommend-
ed that the installation of the mount be done by a professional.
Step 2
Assemble the two L brackets at the desired span by using two of
theshort5/16”diametercup square bolts and KEP nuts throughthe
slots cut into the L brackets as shown.
Step 3
Attach the saddle clamp to the combined L brackets with two
long cup square bolts and two more KEP nuts.
Step 4
Mark the eave with the desired mounting location in preparation
of installation of the L brackets and remaining W bracket to
the gable. Pre-drill,if necessary,and mount the L brackets and
remaining W bracket to the gable.
Note: Make sure to line up the
saddle clamp and W bracket properly as the antenna mast will be
squeezed between them. Warning: Please verify that your mounting
surface will support the combined weight of your mount, mounting
hardware, and antenna mast. Also verify that the mounting surface
is safe to drill through. If in doubt, please contact a professional
installer.
Step 5
Place the antenna mast into the notch in the W brackets. Place
clamp plate on the opposite side of the antenna mast and use
either the long ¼” diameter screws or the U bolts and hex nuts to
tighten down the clamp plate onto the antenna mast clamping it
in place. The ¼” diameter screws are show in the picture. Please
verify that all nuts and screws are securely tightened.
Step 2: Assembling the L brackets
Step 3: Attaching the
saddle clamp to the L
brackets
Enjoy Your Mount!
WARNING: The installer must verify the installation meets all ap-
plicable codes and survival requirements. 6WDU ,QF will not
be held liable for the improper use or installation of its
products.
Step 4: Mounting the W
bracket and L brackets
Step 5: Attaching the
antenna mast
