3idee xia-27dm User manual

www.3idee.eu
xia-27dm VESA Adapter
Assembly instructions
The VESA adapter is compatible with the following Xiaomi (mi.com) products:
27inch desktop monitor.
The VESA adapter allows you to conveniently mount your XIAOMI brand monitor to
a monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and
nuts for this purpose.
If you want to mount your VESA adapter directly to the wall, use suitable screws
and dowels (not included).

2
Assembly instructions
Assembly instruction
Step 1
Place the monitor securely and flat on a soft surface. Now
press into the stand from below with a screwdriver to release
the click. Pull the stand upwards at the same time. (Figure 1)
Figure 1
Step 2
Mount the 3idee VESA adapter to your monitor arm or
directly to the wall. (Figure 2)
Figure 2
Step 3
Once you have completed the last step, please check if all
screws are tightened. (Figure 3)
Figure 3

3Assembly instructions
Step 4
Place the monitor on the adapter so that it audibly clicks into
place.
Note: Apply some pressure if necessary!
Please make sure that you secure the monitor well
with your hand while it is not fully engaged. (Figure
4)
Figure 4
Step 5
Now check if the monitor is properly locked into the VESA
adapter. You can try to pull the monitor towards you while it
should be firmly connected to the VESA adapter. (Figure 5)
Figure 5

4
Assembly instructions
Safety instructions
General notes
Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if
available).
The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC
exhaust or direct sunlight in summer.
PLA is UV resistant but not suitable for high temperatures.
Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the
VESA adapter.
Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the
performance of the VESA adapter.
Material Notes
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant
material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C
and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
Responsible for this content:
3idee Technologies S.à r.l
5, ZA Um Lenster Bierg
L-6125 Junglinster
Luxembourg
Powered by TCPDF (www.tcpdf.org)