510 DESIGN ZEUS User manual

Page 1 of 6
Description QTY
Parts List
Item
P1
P2
Side Panel (Left) 1
ASSEMBLY INSTRUCTIONS
Description: ZEUS ACCENT BENCH
Pre-assembly:
Take out all parts and hardware from box.
Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
Important safety instructions:
Please read carefully all instructions before assembly.
For your safety and ease, assembly by two or more adults is recommended.
Keep instructions for future use.
Side Panel (Right)
P3 Top Panel
P4 Bottom Panel
P5
Base Panel
P6
Vertical Panel
Back Panel
P7
Base Support Panel
P8
Cushion
P9
2
1
1
1
1
1
1
1

P1
P2
P5 X 2
P4
P6
P7 P8
H1
Page 2 of 6
Hardware List
QTY
Description
Item
H1
H2
H3
H4
Alen Wrench
Dowel M8x25 41
26
14
1H5
Sticker
Nail Leg
Screw M6x40
6
Tools Needed (Not Included)
DISCLAIMER:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE FOR ANY DAMAGES
RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
Step 1. Assemble the unit on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.
Unpack the unit and confirm that all the hardware and required parts.
Assembly Procedures:
Step 2. Insert the dowel (H1) into the holes on the edge of panel as shown.
Tap in with a hammer, if necessary.
H1 x 41
Extra Hardware List
QTY
Description
Item
H1
H2
H4
Dowel M8x25
Sticker
Screw M6x40
1
1
1
Hammer

P5
P5
P4
P7
H2
H5
H2
H5
Page 3 of 6
Step 3: Attach the vertical panel (P5) to the bottom panel (P4) with screw (H2) as shown.
Step 4: Attach the back panel (P7) to the previous assembly witrh screw (H2).
H2 x 4
H5 x 1
H2 x 4
H5 x 1
P5
P5
P4

P7
P8
P6
Page 4 of 6
Step 5: Turn the assembled unit lay down. Attach the base support panel (P8) to the previous assembly as shown.
Step 6: Attach the base panel (P6) to the privious assembly as shown.
Step 7: Align and attach the left side panel (P1) to the privious assembly with screw (H2). Repeat the same
procedure to attach the right side panel (P2) at the opposite end.
H2 x 8
H5 x 1
H2
H5
P1
P2
P8
P8
P6
P8
P8
P6
P4

H2 x 10
H3 x 6
H4 x 14
SIDE VIEW
H5 x 1
P3
H5 H2
H3
H4
Page 5 of 6
Step 8: Turn the assembled unit upright. Attach the top panel (P3) to the previous assembly with screw (H2).
Step 9: Turn the assembled unit lay down. Tap in the nail leg (H4) to the previous assembly by hammer as shown.
Step 10: Turn the assembled unit upright. Paste the sticker onto the visible screw as shown.

FINISH
P9
Page 6 of 6
Step 11: Fix the cushion (P9) to the previous assembly as shown.