Technical Bulletin
1370 23023
code a.b.s. S.r.l. (Milan) Italy
Lombardia street 310, 20861 Brugherio
Tel. +39 039 839631 - Fax. +39 039 8396349
Technical data are subject to modification
for improvements without prior notice
Data Sheet
Code Date Check Rev Pag.
Marine Con.Box 23023 25/05/15 benz 3/benz 3/5
Technical specification operating Control Box.
Use instruction.
Control Box consist of two units, a central unit CPU with LCD large backlit display
designed to be installed in engine compartments and remote unit to activate and
control the system from the dash board.
The central unit receives activation signal from the remote unit pushing
down simultaneously both buttons for 3 sec (pict. 1).
The central red LED flashes, until the system operated after it stop to flash.
During the discharge, the pressure switch connected to the system will change its condition (it close the contact) and turn on
the red led “EMPTY” permanently, until the system will be reset.
The red led “EMPTY” is switched on even if there are leaks from the cylinder. In this case, call an authorised service
company of ABS.
The yellow led “FAULT” shows an anomaly from the IN1 - IN2 - IN3 - IN4 - IN5, and according to the set delays on the
outputs, it will generate the activation of the OUTPUT OUT1 - OUT2 - OUT3 - OUT4 - OUT5. After activation of the outputs,
the yellow led “FAULT” will switch off, and the red led “EMPTY”, will be switched on.
The green led “ POWER” indicates that the system is correctly operating
and it will be switched off in case of malfunction or discharge.
- Signal input:
IN1 Pressure switch ( N.C.)
IN2 Temperature detector
IN3 Thermosensittive cable
IN4 Remote activation (Button underglass)
IN5 Further alarm remote available
- Output control relay:
OUT1 Electric actuator
OUT2 Solenoid fuel electro valve solenoid fuel tank
OUT3 Closed shutters ventilation of the engine compartment
OUT4 Solenoid gas kitchen system (N.O.)
OUT5 Acoustic indicator
Program CPU
LX Decreases
RX Increases
Send Change screen
Program level 1
Push the button SEND (pict. 2) for 10 sec. until entry in the function level 1.
Select the language with button RX or LX (pict. 3).
Push “SEND” to change the screen.
Push the button RX or LX to enable or disable the system.
Program level 2
At the finish of the program level 1 “end input” push the button RX and LX together
(pict. 3) for 10 sec. until entry in the function level 2.
With button RX or LX can enable or disable the function of level 2.
(pict. 1)
(pict. 2) (pict. 3)
LXSEND RX
