A/DA ZCT AUTO User manual
Operating manual
Coating thickness tester
Model: ZCT AUTO
Manufacturer Address: WWW. ADAINSTRUMENTS.COM
ZCT AUTO
Table of contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
2. 3
3. 3
4. 4
5. 5
6. 6
7. 6
8. 7
9. 7
10. 11
11. 14
12. 14
13. 15
14. 16
15. 16
Appendix 1:
Appendix 2:
MEASUREMENT FOUNDATION
ZCT AUTO
3
1. Introduction
3. Characteristics
MEASUREMENT FOUNDATION
ZCT AUTO
4
4. Description of main product components
MEASUREMENT FOUNDATION
ZCT AUTO
5
5. Display screen
MEASUREMENT FOUNDATION
ZCT AUTO
6
6. Select measuring modes
7. Battery installation and inspection
MEASUREMENT FOUNDATION
ZCT AUTO
9. Function operating instructions
It is recommended to calibrate the instrument before each measurement. That will allow you to make more
accurate measurements.
1) Tester Calibration
7
8. Startup and check battery status
MEASUREMENT FOUNDATION
ZCT AUTO
8
2) Measuring mode (single measuring < = > continuously measuring):
3) Conversion between meter and the British system
MEASUREMENT FOUNDATION
ZCT AUTO
4) Maximum value / minimum value measurement:
5) Backlight display:
6) Data storage:
7) Check record data:
MEASUREMENT FOUNDATION
ZCT AUTO
8) Clear recorded data:
9) Menu functions setting:
MEASUREMENT FOUNDATION
ZCT AUTO
10. Notice for instrument use
The main factors which have impact on the measuring accuracy of the instrument: the metal magnetic prop-
erty of basal body, the thickness of basal body, edge effect, curvature, surface roughness degree, external
-
tion of test piece and so on.
1) The metal magnetic property of basal body
2) The thickness of basal body mental
3) Edge effect
MEASUREMENT FOUNDATION
ZCT AUTO
4) Curvature
5) Surface roughness degree
7) Attached materials
8) The pressure of measuring head
9) The position of measuring head
MEASUREMENT FOUNDATION
ZCT AUTO
10) Deformation of the test piece
1) The properties of basal body metal
2) The thickness of basal body metal
3) Edge effects
4) Curvature
5) The number of readings
6) Surface Cleanliness
MEASUREMENT FOUNDATION
ZCT AUTO
11. Maintenance
MEASUREMENT FOUNDATION
ZCT AUTO
13. Technical indicators
MEASUREMENT FOUNDATION
ZCT AUTO
Warranty
Exceptions from responsibility
WARRANTY DOESN’T EXTEND TO FOLLOWING CASES:
WARRANTY CARD
Name and model of the product ________________________________________________
Serial number ________________date of sale_______________________
Name of commercial organization _____________________stamp of commercial organization
Warranty period for the instrument explotation is 24 months after the date of original retail purchase. It extends to the equipment, imported
During this warranty period the owner of the product has the right for free repair of his instrument in case of manufacturing defects.
occur in the result of the instrument outage.
The product is received in the state of operability, without any visible damages, in full completeness. It is tested in my presence. I have no
complaints to the product quality. I am familiar with the conditions of qarranty service and i agree.
purchaser signature _______________________________
Before operating you should read service instruction!
If you have any questions about the warranty service and technical support contact seller of this product
__________________________________________________________________________
__________________________________________________________________________
name and model of the instrument
Corresponds to ______________________________________________________________
designation of standard and technical requirements
Data of issue _______________________________________________________________
Stamp of quality control department
Price
Sold ___________________________________ Date of sale ______________________
name of commercial establishment
ADA
MEASUREMENT FOUNDATION
Table of contents
Languages:
