StoneL DeviceNet CK464002A User manual

Valve Communication Solutions DeviceNettm
Commissioning kit
Configure and test DeviceNettm devices
at your desk or workbench

© StoneL Valve Communication Solutions
DeviceNettm Commissioning kit
•Contains all the hardware and software needed to configure and test
DeviceNettm devices.
•Bench test and commission DeviceNettm devices.
•This kit is a must for shop testing and for stroke testing DeviceNettm
devices.
2

© StoneL Valve Communication Solutions
Commissioning kit contents
• DeviceNettm commissioning cable assembly
• Portable 24VDC power supply
• DeviceNettm master simulator software
• Carrying case
3

© StoneL Valve Communication Solutions
Commissioning kit requirements
•120VAC outlet
•Laptop with Windows 7 or later
•USB port
•At least (1) DeviceNettm device
•DeviceNettm cable
4

© StoneL Valve Communication Solutions
Install software
•Install software before connecting dongle to PC.
5

© StoneL Valve Communication Solutions
Commissioning kit connections
6
•Connect Dongle to USB port of PC*
•Connect serial cable to Dongle
•Connect 5-pin plug into device, ensure correct polarity!
•Plug power supply into 120VAC outlet.
* If you connect to a different USB port next time, drivers may need to be re-installed

© StoneL Valve Communication Solutions
Start DeviceNettm Master Simulator software
7

© StoneL Valve Communication Solutions
Search for DeviceNettm device
8
Device found at address 63
Search for attached devices

© StoneL Valve Communication Solutions
Function: Change Device attributes
9
•Change address (MAC ID)
•Change Baud rate

© StoneL Valve Communication Solutions
Change DeviceNettm address and/or baud rate
10