A10 Harmony Controller 2000 User manual

A10 Networks Proprietary Information. All Rights Reserved. © Copyright 2018, A10 Networks, Inc.
Quick Start Guide
This document provides instructions for initial configuration
of your Harmony TM Controller Appliance after it is installed
onto your equipment rack.
Additional Documentation
Complete software and hardware documentation is
available online or by contacting your local A10 Networks
representative.
To view the documentation online:
1. Complete the steps listed in the Installation Guide, and
Safety Guide and then refer the online documentation.
2. Go to http://docs.hc.a10networks.com/4.0.0/a10-hc-
installation.html#installation-of-a10-hardware-appliance
to refer to the Harmony Controller documentation.
Unpacking and Installing
Carefully unpack and check for the following parts, which
should be included with your device:
•Harmony Controller Appliance.
•Quick Start Guide (this document).
•Installation Guide
•Safety Precautions document.
•Accessory Kit (power cable, one Serial to RJ-45 console
cable, 1x Cat5e Ethernet cable).
Before you Begin
What you will need to get started.
To Physically Install the Device:
•Number 2 Phillips screwdriver
•Anti-static strap
To Configure your Device
•Notebook or workstation PC (Windows, Linux, Mac) must
have compatible Ethernet connectivity.
•Terminal Emulation Software (PuTTy, HyperTerminal, or
similar).
•IP address for the management interface.
•IP address for the default gateway.
Initial Configuration for
Harmony Controller 2000 and
Harmony Controller 8000
This section provides initial configuration information for
your Harmony Controller 2000 and Harmony Controller 8000
device.
Follow the steps in this section after your device is
physically installed in your equipment rack.
Connect to the Device by Console
1. Using the included serial, connect the Harmony
Controller Appliance to a computer with terminal
emulation software.
2. Power on the Harmony Controller Appliance. Press the
ON direction of the lower rocker switch.
3. Set the terminal emulation software for:
•Speed (bits): 9600
•Data bits: 8
•Stop bits: 1
•Parity: None
•Flow Control: XON/XOFF
When connected, the login prompt appears on the terminal.
Login Using the CLI
Log in to the device using the default user name admin and
default password a10.

A10 Networks Proprietary Information. All Rights Reserved. © Copyright 2018, A10 Networks, Inc.
Configure the Management Interface
In the factory default configuration, the management interface has the IP address 172.31.31.1/24. And make sure to use a console connection.
To configure the management interface:
1. Configure the management interface IP address and default gateway. The example below shows the CLI commands to set the management IP address to 192.168.2.228:
$ sudo su
# cat /etc/sysconfig/network-scripts/ifcfg-br0 | grep -v "IPADDR" | grep -v "NETMASK" | grep -v "GATEWAY" > /tmp/interface
# echo "IPADDR=192.168.2.228" >> /tmp/interface
# echo "NETMASK=255.255.255.0" >> /tmp/interface
# echo "GATEWAY=192.168.2.1" >> /tmp/interface
# mv -f /tmp/interface /etc/sysconfig/network-scripts/ifcfg-br0
# rm -rf /tmp/interface
# systemctl restart network
2. Use the show interfaces management command to verify that the IP address is configured correctly.
# ip addr show dev br0
Change the Admin Password
After the initial login, it is highly recommended that you secure access to your device by changing the default password.
$ passwd
Changing password for user admin.
Changing password for admin.
(current) UNIX password:
New password:
Retype new password:
passwd: all authentication tokens updated successfully.
$