Aaeon NVR-CV User manual

Network Video Recorder NVR-CV
NVR-CV
Network Video Recorder
Hot-Swappable Tray for
3.5” HDD x 4 or 2.5” HDD x 4
Gigabit Ethernet x 2
COM x 2, USB2.0 x 6
VGA x 1, DVI-D x 1
NVR-CV Manual 1st Ed.
April 2013

Network Video Recorder NVR-CV
i
Copyright Notice
This document is copyrighted, 2013. All rights are reserved. The
original manufacturer reserves the right to make improvements to the
products described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated, or
transmitted in any form or by any means without the prior written
permission of the original manufacturer. Information provided in this
manual is intended to be accurate and reliable. However, the original
manufacturer assumes no responsibility for its use, or for any in-
fringements upon the rights of third parties that may result from its
use.
The material in this document is for product information only and is
subject to change without notice. While reasonable efforts have been
made in the preparation of this document to assure its accuracy,
AAEON assumes no liabilities resulting from errors or omissions in
this document, or from the use of the information contained herein.
AAEON reserves the right to make changes in the product design
without notice to its users.

Network Video Recorder NVR-CV
ii
Acknowledgments
All other products’ name or trademarks are properties of their
respective owners.
AMI is a trademark of American Megatrends Inc.
CompactFlash™ is a trademark of the Compact Flash
Association.
Intel®is a trademark of Intel®Corporation.
Microsoft Windows®is a registered trademark of Microsoft Corp.
ITE is a trademark of Integrated Technology Express, Inc.
IBM, PC/AT, PS/2, and VGA are trademarks of International
Business Machines Corporation.
SoundBlaster is a trademark of Creative Labs, Inc.
All other product names or trademarks are properties of their
respective owners.

Network Video Recorder NVR-CV
iii
Packing List
Before you begin installing your card, please make sure that the
following materials have been shipped:
1 CD-ROM for Manual (in PDF Format) and Drivers
1 NVR-CV
If any of these items should be missing or damaged, please
contact your distributor or sales representative immediately.

Network Video Recorder NVR-CV
iv
Contents
Chapter 1 General Information
1.1 Introduction................................................................1-2
1.2 Features....................................................................1-3
1.3 Specifications............................................................1-4
Chapter 2 Hardware Installation
2.1 Mechanical Drawing..................................................2-2
2.2 Installing the 3.5” Hard Disk Drive.............................2-3
Chapter 3 Driver Installation
3.1 Installation.................................................................3-3
Chapter 4 I/O Information
4.1 I/O Address Map .......................................................4-2
4.2 1st MB Memory Address Map....................................4-4
4.3 IRQ Mapping Chart ...................................................4-5
4.4 DMA Channel Assignments......................................4-7

Network Video Recorder NVR-CV
Chapter 1 General Information 1- 1
General
Chapter
1
Information

Network Video Recorder NVR-CV
1.1 Introduction
NVR-CV adopts the Intel®AtomTM D2550 Dual Core Processor and
equips with Intel®NM10 chipset. Moreover, the system memory
features two 204-pin Single Channel DDR3 1066/800 non-ECC,
un-buffered DIMM memory up to 4GB. It deploys two LAN ports
that consist of 10/100/1000Base-TX Ethernet RJ-45 ports.
NVR-CV features desktop form factor for network video recorder
applications.
This NVR-CV supports up to four 3.5” Hard Disk Drive or four 2.5”
SATA swappable HDD. Moreover, the flexible expansion interface
features one PCI-E[x4] slot. In addition, this model supports two
COM ports, and six USB2.0 ports ( two USB2.0 ports on the ear
and four USB2.0 ports on the rear.) Furthermore, the NVR-CV can
support dual displays with one VGA and one DVI-D.
Chapter 1 General Information 1- 2

Network Video Recorder NVR-CV
1.2 Features
Intel®Atom™D2550 Dual Core Processor
Intel®NM10 Chipset
204-pin Single Channel DDR3 1066/800 Non-ECC,
Un-buffered DIMM Memory Up To 4GB
10/100/1000Base-TX Ethernet x 2
Hot-Swappable Tray for 3.5” HDD x 4 or 2.5” HDD x 4
COM x 2
USB2.0 x 6
VGA x 1,DVI-D x 1
Audio Line-out, Line-in, Mic-in
RAID 0/1/5/10 support
Supports Linux OS and Windows®XP embedded
Standard (optional)
Chapter 1 General Information 1- 3

Network Video Recorder NVR-CV
1.3 Specifications
System
CPU Intel®Atom™ D2550 Dual Core
Processor, 1.83 GHz
Chipset Intel®NM10
System Memory 204-pin Single Channel DDR3
1066/800 Non-ECC, Un-buffered
Memory, support up to 4G
LCD/CRT Controller Intel®NM10
Ethernet Realtek 8111E for
10/100/1000Base-TX, RJ-45 x 2
BIOS AMI Plug & Play BIOS – 32MB SPI
Serial ATA SATA x 6
Wake on LAN Yes
Hardware Status
Monitoring
Supports Power Supply Voltage,
Fan Speed and Temperature
Monitoring
Expansion Interface PCI-E[x4] x 1
Watchdog Timer Programmable 1~255 steps
System Reset
Storage Supports 3.5” or 2.5” removable
SATA HDD tray x 4
Front I/O Port Power Button x 1
Reset Button x 1
Power & HDD LED
USB2.0 x 2
Rear I/O Port VGA x 1
DVI-D x 1
RJ-45 x 2
USB2.0 x 4
Audio Jack x 3
RAID Support 0/1/5/10
Chapter 1 General Information 1- 4

Network Video Recorder NVR-CV
Chapter 1 General Information 1- 5
Mechanical
Dimension 7.87” x 9.84” x 11.93” (200mm x
250mm x 303mm)
Gross Weight 17.6 lb (8 Kg)
Net Weight 15.4 lb (7 Kg)
Environmental
Operating Temperature 32°F ~ 104°F (0°C ~ 40°C)
Storage Temperature -4°F ~ 140°F (-20°C ~ 60°C)
Storage Humidity 10%~80% @40°C;
non-condensing
Vibration 0.5 g rms/ 5~500Hz/ operation
(2.5” HDD)
1.5 g rms/ 5~500Hz/ non-operation
Shock 10 G peak acceleration (11 m sec.
duration) operation
20 G peak acceleration (11 m sec.
duration) non-operation
Power Supply
DC Output 200W
AC Input Voltage Range 100~240VAC, 47~63HZ, 3.5A

Network Video Recorder NVR-CV
Chapter2HardwareInstallation2-1
Hardware
Installation
Chapter
2

Network Video Recorder NVR-CV
2.1 Mechanical Drawing
Chapter 2 Hardware Installation 2-2

Network Video Recorder NVR-CV
2.2 Installing the 3.5” Hard Disk Drive
Step 1: Press HDD to the right to remove the HDD tray
Chapter 2 Hardware Installation 2-3

Network Video Recorder NVR-CV
Step 2: Put the HDD to the HDD bracket (tray)
Chapter 2 Hardware Installation 2-4

Network Video Recorder NVR-CV
Step 3: Fasten the HDD on the bottom bracket with three screws
Step 4: Insert the HDD tray back to the chassis
Chapter 2 Hardware Installation 2-5

Network Video Recorder NVR-CV
Chapter 2 Hardware Installation 2-6
Step 5: Push the HDD tray to the chassis until it has been firmly
locked

Network Video Recorder NVR-CV
Chapter 3 Driver Installation 3-1
Driver
Chapter
3
Installation

Network Video Recorder NVR-CV
The NVR-CV comes with an AutoRun CD-ROM that contains all
drivers and utilities that can help you to install the driver
automatically.
Insert the driver CD, the driver CD-title will auto start and show the
installation guide. If not, please follow the sequence below to install
the drivers.
Follow the sequence below to install the drivers:
Step 1 – Install Chipset Driver
Step 2 – Install VGA Driver
Step 3 – Install LAN Driver
Step 4 – Install Audio Driver
Step 5 – Install AHCI Driver
Step 6 – Install Serial Port Driver (Optional)
Please read instructions below for further detailed installations.
Chapter 3 Driver Installation 3-2

Network Video Recorder NVR-CV
3.1 Installation
Insert the NVR-CV CD-ROM into the CD -ROM drive and install the
drivers from Step 1 to Step 6 in order.
Step 1 – Install Chipset Driver
1. Click on the Step 1 - INF folder and double click on the
infinst_autol file
2. Follow the instructions that the window shows
3. The system will help you install the driver automatically
Step 2 – Install VGA Driver
1. Click on the Step 2 - VGA folder and select the OS folder
your system is
2. Double click on the .exe file located in each OS folder
3. Follow the instructions that the window shows
4. The system will help you install the driver automatically
Step 3 – Install LAN Driver
1. Click on the Step 3 - LAN folder and select the OS folder
your system is
2. Double click on the setup.exe file located in each OS
folder
3. Follow the instructions that the window shows
4. The system will help you install the driver automatically
Chapter 3 Driver Installation 3-3

Network Video Recorder NVR-CV
Chapter 3 Driver Installation 3-4
Step 4 – Install Audio Driver
1. Click on the Step 4 - AUDIO folder and double click on
the SETUP.exe file
2. Follow the instructions that the window shows
3. The system will help you install the driver automatically
Step 5 – Install AHCI Driver
1. Click on the Step 5 - AHCI folder and select the folder of
AP
2. Double click on the iata_cd.exe file
3. Follow the instructions that the window shows
4. The system will help you install the driver automatically
Step 6 – Install Serial Port Driver (Optional)
1. Click on the Step 6 - Serial Port Driver (Optional) and
double click on the patch.bat file
2. Follow the instructions that the window shows
3. The system will help you install the driver automatically