4
WEIGHING
Before weighing
Be aware of the Automatic power-off function.
If this unit is left ON and the stable indicator is displayed, an automatic
power-off function turns power off after approximately 5 minutes. To disable
this function, press the [ON/OFF] key while pressing the [RE-ZERO] key.
p- XX will be displayed and the scale returns to the weighing mode.
Error message
aeaaaa Overload
a----aThe scale zero is out of range
albaaa Low battery
Calibration may be required before weighing
Read “CALIBRATION” first and if necessary, calibrate your scale for
accurate weighing.
Weighing procedures
1. Turn on the scale.
Press the [ON/OFF] key to turn on the scale. Then the scale displays all
segments for a few seconds and then 0 will be displayed.
2. Start weighing
If you do not use a container for weighing,
Verify the reading is 0 . If not, press the [RE-ZERO] key to display
0 . Place objects on the weighing platform to weigh. When the reading
becomes stable, the stable indicator is displayed.
If you use a container for weighing,
Place an empty container on the platform.
Wait for the stable indicator to be displayed and then press the
[RE-ZERO] key. Place the objects to be weighed in the container. When
the reading becomes stable, the stable indicator is displayed.
Select the weighing unit, --- Only for the “g/lb” or “g/lb-oz” model ---
If you use the “g/lb” or “g/lb-oz” model, press the [UNITS] key to select
“g” or “lb”, or “g” or “lb-oz” for the weighing unit. Normally scales power up
in “lb” or “lb-oz” when shipped from the factory.
To power up with “g” selected:
Turn the scale off. Press and hold the [UNITS] key, then press the
[ON/OFF] key. The scale will start with “g”. To return to the original setting
repeat this instruction.
Note: g/lb model: HL-1000WP
g/lb-oz model: HL-300WP/HL-3000WP
