AAT KDH-C150MQR User manual

Proximity card and QR codes reader –Installation manual
AAT Holding S.A. All rights reserved.
Installation Manual
Mifare Card and QR Code Reader
KDH-C150MQR
Version 1.0

Proximity card and QR codes reader –Installation manual
AAT Holding S.A. All rights reserved.
1. Introduction
Proximity card reader and QR code reader type KDH-C150MQR QR codes is
designed to work in access control systems.
Reader can work with controllers with Wiegand interface. Readers allow to read
the user identification number (UID) from Mifare Classic cards and QR code
from the smartphone display or printed on a piece of paper.
Reader characteristics
•Working with controllers with Wiegand port
•Proximity card (13,56 MHz) –Mifare Classic
•Read QR codes
•Power supply 12 VDC
Technical parameters
Name of parameters or function
Parameters value or description
- Supply voltage
12 VDC +/- 10%
- Current load
< 150mA
- Proximity card reading range
From 1 to 5 cm
- QR code reading range
From 5 to 20 cm
- Proximity card type
Mifare Classic
- Wiegand format
26/34 Wiegand
- QR Code
Tak, number 1-10 characters
- Maximum distance from controller
30m
- Enviroment
For indoor installation
- operating temperature
-20°C to +60°C
- relative humidity
10 % - 90% RH
- dimensions
120mm x 66 mm x 23 mm
KDH-C150MQR

Proximity card and QR codes reader –Installation manual
AAT Holding S.A. All rights reserved.
Wiring markings
Color
Function
Description
Red
+12V
Power +12 VDC
Black
GND
Power –12 VDC
Green
D0
Wiegand Data 0
White
D1
Wiegand Data 1
Purple
Buzzer/LED
Signal of read the card
Grey
Wiegand format
Change format to W34
Installing the Reader
•Separate the back of the housing case with holes and use it as a template
•Drill 2 holes in the wall for the screws and one for the cable
•Insert the attached wall plugs into the holes
•Screw the back part of the housing case to the wall with the attached
screws
•Move the reader cables through the hole and connect connector
•Mount the reader on the base and secure from the bottom with a special
screw
QR codes can be generated and send to user directly from NMS AC version 4.0
and higher. Another way is to use any QR code generator. The QR code must
contain only digits and cannot be longer than 10 digits.
Note! To increase the security of the access control system, the KDH-C150MQR
card reader should be installed on a guest-only passage. Other users of the
system should not have permission to use this passage. This will avoid an attack
involving the generation of a QR code with the employee card number by
unauthorized persons.

Proximity card and QR codes reader –Installation manual
AAT Holding S.A. All rights reserved.