ABB ACS350 Series User manual

ACS350 and ACS150
MUL1-R3 Installation Instructions
© 2005 ABB Oy. All Rights Reserved. 3AFE68620023 rev. B / 7.12.2005
1
2. Fasten the gland box frame to wall with four M4 screws (not
included).
2
1. Fasten the gland box frame to drive with two M4×12 screws.
4. If control cables or fieldbus option modules will be installed,
remove the detachable lid (4) from the gland box cover.
4
WARNING! Before installing MUL1-R3
option, read the safety instructions and
mechanical and electrical installation
instructions in the drive user’s manual.
Follow the instructions when installing,
operating and servicing the drive. If
ignored, physical injury or death may
follow, or damage may occur to the
drive, motor or driven equipment.
3. If using FPBA-01 or FCAN-01 option module, remove part
from gland box frame by bending it.
3
5. With any fieldbus option module except FRSA-00, install the
option grounding plate to the gland box frame. See Mechanical
installation in the drive manual.
5

ABB Oy AC Drives P.O. Box 184 FIN-00381 HELSINKI FINLAND Tel. [phone], Fax: [phone], Internet: http://www.abb.com
10
11
10. Fasten the hood to drive with two M3×12 screws.
11. Fasten the hood to wall with one M4 screw (not included). 12. Drive with MUL1-R3 option installed.
9
9. Install the hood. First position the front edge carefully, then
press the hood downwards until it snaps on.
8
6. Install the clamp for the control cable, or if cables are run in
conduits, replace all clamps with suitable glands (not included).
Run cables through the clamps and tighten. Strip cable ends.
Fasten the grounding conductor (PE) of the input power cable
and the twisted shield of motor cable under the grounding
clamps. Connect the connectors to appropriate terminals. See
Electrical installation in the drive manual.
7
7. Install the gland box cover.
8. Fasten the cover with two M4×12 screws.
Clamp
Grounding
clamps