ABI INTERIORS 316 SS User manual

IN-WALL MIN IMAL MIXE R BO DY - 31 6 S S
Dis cla imer: P ro d u c ts in th is ma n u a l mu s t by la w b e in s talled b y licen s ed an d reg is tered tra d es p eo p le in a cco rd a n ce w ith th e releva n t stan d a rds . A B I a n d th e ma n u fa ctu rer/d is trib u to r
res erve t h e rig h t to va ry s p ecif ic a tio n s o r d elete mo d els fro m t h eir ra n g e w ith o u t prio r n o tif ic a t io n . Dimen s io n s a re n o min a l mea s u remen ts o n ly. Th e in f o rmatio n lis ted is co rrect at th e time
o f p u b lica tio n , h o w ever A B I a n d th e man u f a c tu rer/d is trib u to r ta kes n o res p o n s ib ility fo r p rin tin g erro rs. C o p yrig h t © A B I I n terio rs 2 02 2 Pty Ltd
SPECIFICATIONS
RECOMMENDED USE Domestic
MATERIAL 316 Stainless Steel
PRESSURE RATING Recommended minimum working pressure 150kPa
Recommended maximum working pressure 500kPa
Hot and cold water inlet pressure should be equal
TEMPERATURE RATING Maximum continuous working temperature 75°C
If the water temperature exceeds 75°C, an approved
tempering valve must be fitted
STANDARDS AS/NZS 3718 :2005, WM-022852
AS/NZS 3718:2005
WM-022852

Note: Fo r handle kit installation guide plea s e r efe r to their respective install guides. This can be found on our website.
1. Body
2. Fixing Screws
3. Cartridge
4. Locking nut
IN THE BOX (IN-WALL)
2Attach water supply and water outlet.
TEST AND CHECK FOR LEAKS. 3
DO NOT WATERPROOF SLEEVE.
Please ensure that the hole is big enough to allow
for the sleeve to slide on at fit-off stage.
1Fasten screws to secure the wall
mixer into wall structure.
Note for Aliro Handle Kit Install:
Ensure setback is compliant with
AS1428.1:2021
ROUGH IN
1
2
3
4
INSTALLATION GUIDE
Note: This product must be installed by a licensed plumber. This is a general installation guide - there are many factors involved that
can alter the installation method. AU/NZ: For installations within Australia and New Zealand, this product must be installed in
compliance with AS/NZS 3500. UK: For installations in the United Kingdom this product must be installed in compliance with the
Water Supply (Water Fittings) Regulations and Water Supply (Water Fittings) (Scotland) Byelaws. Other: For installations outside
these countries, this product must be installed in compliance with the standards in your respective country.
Regularly clean with mild
liquid detergent or soap
and water
DO NOT use cream
cleaners or bleach.
These substances are
abrasive
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material
See Specification image for finish wall setback
ø47mm
Sheeting and waterproof layer can
now be applied.
*Ensure cutout in finish wall is
47mm diameter.