ABI INTERIORS NAMIKA 15653 User manual

NAMIKA KITCHE N MIXE R
Dis cla imer: P ro d u c ts in th is ma n u a l mu s t by la w b e in s talled b y licen s ed an d reg is tered tra d es p eo p le in a cco rd a n ce w ith th e releva n t stan d a rds . A B I a n d th e ma n u fa ctu rer/d is trib u to r
res erve t h e rig h t to va ry s p ecif ic a tio n s o r d elete mo d els fro m t h eir ra n g e w ith o u t prio r n o tif ic a t io n . Dimen s io n s a re n o min a l mea s u remen ts o n ly. Th e in f o rma tio n lis t ed is co rrect at th e time
o f p u b lica tio n , h o w ever A B I a n d th e man u f a c tu rer/d is trib u to r ta kes n o res p o n s ib ility fo r p rin tin g erro rs. C o p yrig h t © A B I I n terio rs 2 02 2 Pty Ltd
SPECIFICATIONS
RECOMMENDED USE Domestic/Commercial
MATERIAL Solid Brass
PRESSURE RATING Recommended minimum working pressure 150kPa
Recommended maximum working pressure 500kPa
Hot and cold water inlet pressure should be equal
TEMPERATURE RATING Maximum continuous working temperature 75°C
If the water temperature exceeds 75°C, an approved tempering valve
must be fitted
SUITABLE HOT WATER UNITS Storage tank: Yes
Continuous flow:Yes
Gravity feed: Not suitable
STANDARDS WELS 5 Star, 6L/min, T41708
AS/NZS 3718:2005
WM-022852

INS TA LLATION G UIDE
Ø35mm
MAX 30mm
1 2 3
45
What’s in the Box
1 Spout
2 Rubber O-ring
3 Aerator
5 Grubscre w
6 Body
7 Dress ring
8-9 Flexible hoses
10 Rubber shoe plate
12 Cartridge
11 Horse shoe plate
13 Lockingnut
14 Dome
15 Grub screw
16 Handle
HOT COLD
OFF
ON
25°
90 °
Operation
4Spout tip
Drill a 35mm hole in desired install location.
As shown in left figure, connect the
flexi hoses.
Attach the two flexible hoses to water
supply.
Fix the bolts to the bottom of the body,
hand tighten.
Put the mixer into the hole. Pass
the horseshoe plates through the
bolts, fasten the nuts and tighten.
Further tighten bolts with a
screwdriver.
4
2
1
3
6
7
10
11
12 13 14
15
16
8
G1/2
9
5
Regularly clean with mild
liquid detergent or soap
and water
DO NOT use cream
cleaners or bleach.
These substances are
abrasive
DO NOT use cleaning
pads with abrasive
surfaces as this may
scratch the material
Note: This product must be installed by a licensed plumber. This is a general installation guide - there are many factors involved that can
alter the installation method. AU/NZ: For installations within Australia and New Zealand, this product must be installed in compliance with
AS/NZS 3500. UK: For installations in the United Kingdom this product must be installed in compliance with the Water Supply (Water
Fittings) Regulations and Water Supply (Water Fittings) (Scotland) Byelaws. Other: For installations outside these countries, this product
must be installed in compliance with the standards in your respective country.