ABQINDUSTRIAL SKIPPER 5 User manual

SKIPPER 5 MOISTURE METER
QUICK STARTGUIDE
- SMM5 -
For Marine Surveying
OPERATION
•Last scale used is memorized when power is shut down
and automatically selected next time unit is powered up.
•Hold/freeze: Press once. In HOLD mode the Hold LED
will flash continuously. Press again to release hold.
(If powered down while on Hold, the Skipper 5 will retain
information until powered up and hold is pressed again to
release)
•Turn Audio signal on or off by pressing HOLD/AUDIO
twice in quick succession.
•Automatic power timeout (5 mins) conserves battery life.
•Press to switch ON/OFF .
Press to select the required mode/scale.
•Press fully against the surface of the material
•When using with the app, place and press the meter on
the surface, record the reading, lift and repeat.
•Readings are instant and displayed on analog dial.
Distributed by: ABQ Industrial LP USA
Tel: [phone] eFax: [phone]
Web: https://www.abqindustrial.net E-mail: [email protected]
Distributed by: ABQ Industrial LP USA
Tel: [phone] eFax: [phone]
Web: https://www.abqindustrial.net E-mail: [email protected]

Press to switch ON/OFF.
Press to select the required mode/scale.
SCALES
DUAL-DEPTH PENETRATION
MATERIALS AND SCALE SELECTION
•
•
•
•
•
Upper scale (5-30) indicates moisture content (MC%)
of wood when used on wood products.
Shallow depth up to ⅜” (10mm)
Deep depth up to 1¼" (30mm)
The Skipper 5 has 3 ranges of sensitivity:
Hardwood
Shallow Depth
G.R.P.
•
•
BLUETOOTH
Press to switch Bluetooth ON/OFF
Readings will be sent to the Tramex App on your mobile device.
Lower Scale (0-100) is a comparative scale and may be
used for recording and compar-ing moisture condition
in materials other than wood.
QUICK START GUIDE
For Marine Surveying
CALIBRATION & WARRANTY
Obtain Warranty online: tramexmeters.com/register
Annual calibrations are recommended as best practice.
Calibration Check Boxes can be purchased for regular checks.
•
•
•
•
•
•
•
TROUBLESHOOTING
Batteries are low and will soon need to be replaced.
Single LED flashing and meter frozen.
Skipper 5 is in HOLD mode.
Press HOLD button to release.
All LEDs flashing when unit is powered up.
USER GUIDE ONLINE
Please use the following link or QR code to access the complete
User Guide online: http://l.ead.me/bb3Oxw
Distributed by: ABQ Industrial LP USA
Tel: [phone] eFax: [phone]
Web: https://www.abqindustrial.net E-mail: [email protected]
Distributed by: ABQ Industrial LP USA
Tel: [phone] eFax: [phone]
Web: https://www.abqindustrial.net E-mail: [email protected]