Accent GLF Series User manual

USER MANUAL
GLF Series
NSF61/ANSI372 Certified
Lead-Free Water Meter
with Totalizer Only
GLF-062 • GLF-075 • GLF-100/100F
GLF-150 • GLF-200
NSF61/ANSI372 Certified Lead-Free
Water Meters with Totalizer Only
GLF-062 to GLF-200
www.accent-control.com •2101 Potshop Lane •Norristown, PA 19403 •888-265-5632
www.accent-control.com •2101 Potshop Lane •Norristown, PA 19403 •888-265-5632
improper installation, frost/freeze damage or using the
meter outside of its specific operating parameters
(especially temperature and flow ranges).
In no event shall Accent Control Systems be liable
for incidental or consequential damages of any kind,
including but not limited to loss of profits or revenue,
loss of use, cost of capital, cost of substitute equipment,
facilities or services, downtime costs, delays and claims
of customers of the customer or other third parties.
Warranty
G F water meters are warranted to perform to AWWA
new meter accuracy standards, and to be free from defects
in materials and workmanship for a period of 12 months
from date of shipment. If a meter does not perform as
warranted, Accent Control Systems will repair it free of
charge subject to the terms of this warranty.
Accent Control Systems liability under this performance
warranty is expressly limited to the repair or replacement
of the meter upon the customer’s returning the complete
meter prepaid to:
Accent Control Systems
Repair Department
2101 Potshop Lane
Norristown, PA 19403
This performance guarantee shall not be applicable to
meters which have been damaged by aggressive water
conditions, foreign matter in media, mis-application,
willful misconduct, negligence, vandalism, act of God,

NSF61/ANSI372 Certified Lead-Free
Water Meters with Totalizer Only
GLF-062 to GLF-200
General Information
G F water meters use the internationally-accepted
multi-jet principle. A gear train drives the register
totalizer dials.
Accuracy Curve
Inlet Strainer
Clean the strainer yearly, or as required, depending on
water condition. Pull out the strainer or back-flush the
meter to loosen trapped particulates.
Cali ration
New meters are factory-tested to meet the AWWA
C-708 Multi-Jet Meter accuracy specification.
Suggested Meter Installation
• Thoroughly flush the service line upstream of the
meter to remove dirt and debris.
• Set the meter inline. Water meters are recommended to
be installed horizontally with the register facing upwards.
• Make sure the water flow follows the arrow cast on
the meter body.
• Slowly open any upstream valves to prevent damage
to the meter.
NSF61/ANSI372 Certified Lead-Free
Water Meters with Totalizer Only
GLF-062 to GLF-200
Internal Parts Replacement
All the internal parts of the meter lift out as a unit, after the
top has been unscrewed. The lens can then be removed
and internal assembly lifted out. If necessary, turn the meter
upside down and tap one end lightly on a countertop to
loosen internals. The assembly can be separated by hand.
www.accent-control.com •2101 Potshop Lane •Norristown, PA 19403 •888-265-5632 www.accent-control.com •2101 Potshop Lane •Norristown, PA 19403 •888-265-5632
1.5%
1/2”, 3/4” meters only
1”, 1 1/2” and 2” meters
Main Technical Data
US gpm
Minimum reading US gallon
US gpm
US gpm
US gpm
062 - 5/8”x1/2” 075 - 5/8”x3/4” 100 - 3/4”x1”100F - 1” 150 - 1 1/2” 200 - 2”
20 20 30 50 100 160
10 10 15 25 50 80
1 1 2 3 5 8
0.25 0.25 0.5 0.75 1.5 2
0.005 0.005 0.05 0.05 0.05 0.05
Specifications
Specifications
Cert f cat on Meters comply with NSF/ANSI61
AnnexG, NSF/ANSI372, and conforms
with lead content requirements for
“lead-free”plumbing as defined by the
U.S. Safe Drinking Water Act effective
Jan. 1, 2014
Temperature 105˚ F (40˚ C) max
Pressure 150 psi operating max
Mater als Body/cplgs EcoBrass*
Internals Engineered thermoplastic
Magnet Alnico
Accuracy +/-1.5% of reading within Qt-Qmax
Sensor Reed switch
Max mum Current 20 mA
Max mum Voltage 24 Vdc or Vac
Cable Length 12’ (4m) std (2000’ max run)
*EcoB ass B onze Alloy-Lead composition is less than 0.1% by weight
3%
Flow (GPH)
Parts 5/8”x1/2” 5/8”x3/4” 3/4”x1” 1” 1 1/2” 2”
1.1 id/Hinge Assembly-Totalizer A0724 A0724 A0725 A0725 A0726 A0727
2.1 Retaining Ring-Totalizer A0728 A0728 A0729 A0729 A0730 A0731
3ens Gasket A0604 A0604 A0605 A0605 A0606 A0606
4.1 ens-Totalizer A0003 A0003 A0003 A0003 A0003 A0003
5O-Ring A0644 A0644 A0645 A0645 A0646 A0646
7A Internal Assembly-Gallons A0618 A0619 A0620 A0621 A0622 A0623
7B Internal Assembly-Cubic ft. A0718 A0719 A0720 A0721 A0722 A0723
8 Tubular Strainer A0016 A0016 A0018 A0018 A0020 A0022
9Internal Strainer A0015 A0015 A0017 A0017 A0019 A0021
10 Coupling Gasket, 2/meter A0226 A0228 A0230 A0230 A0232 A0234
11 , Coupling Assembly, 2/meter A0225 A0227 A0229 A0229 A0231 A0233

NSF61/ANSI372 Certified Lead-Free
Water Meters with Totalizer Only
GLF-062 to GLF-200
General Information
G F water meters use the internationally-accepted
multi-jet principle. A gear train drives the register
totalizer dials.
Accuracy Curve
Inlet Strainer
Clean the strainer yearly, or as required, depending on
water condition. Pull out the strainer or back-flush the
meter to loosen trapped particulates.
Cali ration
New meters are factory-tested to meet the AWWA
C-708 Multi-Jet Meter accuracy specification.
Suggested Meter Installation
• Thoroughly flush the service line upstream of the
meter to remove dirt and debris.
• Set the meter inline. Water meters are recommended to
be installed horizontally with the register facing upwards.
• Make sure the water flow follows the arrow cast on
the meter body.
• Slowly open any upstream valves to prevent damage
to the meter.
NSF61/ANSI372 Certified Lead-Free
Water Meters with Totalizer Only
GLF-062 to GLF-200
Internal Parts Replacement
All the internal parts of the meter lift out as a unit, after the
top has been unscrewed. The lens can then be removed
and internal assembly lifted out. If necessary, turn the meter
upside down and tap one end lightly on a countertop to
loosen internals. The assembly can be separated by hand.
www.accent-control.com •2101 Potshop Lane •Norristown, PA 19403 •888-265-5632 www.accent-control.com •2101 Potshop Lane •Norristown, PA 19403 •888-265-5632
1.5%
1/2”, 3/4” meters only
1”, 1 1/2” and 2” meters
Main Technical Data
US gpm
Minimum reading US gallon
US gpm
US gpm
US gpm
062 - 5/8”x1/2” 075 - 5/8”x3/4” 100 - 3/4”x1”100F - 1” 150 - 1 1/2” 200 - 2”
20 20 30 50 100 160
10 10 15 25 50 80
1 1 2 3 5 8
0.25 0.25 0.5 0.75 1.5 2
0.005 0.005 0.05 0.05 0.05 0.05
Specifications
Specifications
Cert f cat on Meters comply with NSF/ANSI61
AnnexG, NSF/ANSI372, and conforms
with lead content requirements for
“lead-free”plumbing as defined by the
U.S. Safe Drinking Water Act effective
Jan. 1, 2014
Temperature 105˚ F (40˚ C) max
Pressure 150 psi operating max
Mater als Body/cplgs EcoBrass*
Internals Engineered thermoplastic
Magnet Alnico
Accuracy +/-1.5% of reading within Qt-Qmax
Sensor Reed switch
Max mum Current 20 mA
Max mum Voltage 24 Vdc or Vac
Cable Length 12’ (4m) std (2000’ max run)
*EcoB ass B onze Alloy-Lead composition is less than 0.1% by weight
3%
Flow (GPH)
Parts 5/8”x1/2” 5/8”x3/4” 3/4”x1” 1” 1 1/2” 2”
1.1 id/Hinge Assembly-Totalizer A0724 A0724 A0725 A0725 A0726 A0727
2.1 Retaining Ring-Totalizer A0728 A0728 A0729 A0729 A0730 A0731
3ens Gasket A0604 A0604 A0605 A0605 A0606 A0606
4.1 ens-Totalizer A0003 A0003 A0003 A0003 A0003 A0003
5O-Ring A0644 A0644 A0645 A0645 A0646 A0646
7A Internal Assembly-Gallons A0618 A0619 A0620 A0621 A0622 A0623
7B Internal Assembly-Cubic ft. A0718 A0719 A0720 A0721 A0722 A0723
8 Tubular Strainer A0016 A0016 A0018 A0018 A0020 A0022
9Internal Strainer A0015 A0015 A0017 A0017 A0019 A0021
10 Coupling Gasket, 2/meter A0226 A0228 A0230 A0230 A0232 A0234
11 , Coupling Assembly, 2/meter A0225 A0227 A0229 A0229 A0231 A0233

USER MANUAL
GLF Series
NSF61/ANSI372 Certified
Lead-Free Water Meter
with Totalizer Only
GLF-062 • GLF-075 • GLF-100/100F
GLF-150 • GLF-200
NSF61/ANSI372 Certified Lead-Free
Water Meters with Totalizer Only
GLF-062 to GLF-200
www.accent-control.com •2101 Potshop Lane •Norristown, PA 19403 •888-265-5632
www.accent-control.com •2101 Potshop Lane •Norristown, PA 19403 •888-265-5632
improper installation, frost/freeze damage or using the
meter outside of its specific operating parameters
(especially temperature and flow ranges).
In no event shall Accent Control Systems be liable
for incidental or consequential damages of any kind,
including but not limited to loss of profits or revenue,
loss of use, cost of capital, cost of substitute equipment,
facilities or services, downtime costs, delays and claims
of customers of the customer or other third parties.
Warranty
G F water meters are warranted to perform to AWWA
new meter accuracy standards, and to be free from defects
in materials and workmanship for a period of 12 months
from date of shipment. If a meter does not perform as
warranted, Accent Control Systems will repair it free of
charge subject to the terms of this warranty.
Accent Control Systems liability under this performance
warranty is expressly limited to the repair or replacement
of the meter upon the customer’s returning the complete
meter prepaid to:
Accent Control Systems
Repair Department
2101 Potshop Lane
Norristown, PA 19403
This performance guarantee shall not be applicable to
meters which have been damaged by aggressive water
conditions, foreign matter in media, mis-application,
willful misconduct, negligence, vandalism, act of God,