Accu-Scope EXI-410 Series User manual

EXI-410 Microscope Series
Filter Cube Installation
IMPORTANT
To avoid damage to the filter
cubes, they must be carefully
and properly installed.
Cubes are numbered
according to their position in
the turret – match the number
on the cube to the position
number on the turret.
To install:
NOTES: Each filter cube has a notch
on the bottom right side of the cube
slider dovetail (see above).Position
the filter cube as shown above to insert
into the turret.
There is a securing pin on the inside of
the turret for each filter position. The
filter cube will be installed properly
when the notch on the cube clicks into
place.

1. To install a filter cube, align the cube
notch with the securing pin on the
inside right of the turret receptacle
and carefully slide the cube in until it
clicks into place.
2. Shown here, the filter cube is
properly seated and installed.
NOTE
●Never touch any area of the filter
cube other than the black casing.
●Be sure to carefully reinstall the
turret cover to avoid breakage.