Accutire MS-4034 User manual

Buttons
White Flash Light
LCD Display
Belt Cutter
Hammer
Legs
Stand
Tire Gauge nozzle
Emergency
Flash Lights

psi on display.
3. Press repeatedly to scroll through units.
4. Gauge is ready for operation.
5. Gauge will automatically shut off in 10 seconds.

and new batteries.
Emergency /Flare tool stand
1. Unfold 3 legs, pull the stand away from the gauge (picture 1-1, 1-2, 1-3)
2. Turn the stand upside down (picture2-1) and push the stand back to the
gauge (picture2-2), (Note: the slot in stand indicate the right direction
matching with gauge). Then the gauge can stand firmly on the flat ground.
153psi / 10.60bar / 1060kPa / 10.60kg/cm²
2.9V

2-2
1-2 1-3
2-1
1-1

6
Install Batteries:
1. Remove the battery door by pressing and sliding (Picture 1).
Note: To ensure the emergency light works well, you need to stand the
tripod tool when you use the flash light in emergency.
2. Install 3x AA batteries proper orientation and correct +/-polarity
(Picture 2&3).
3. Replace the battery door as picture (Picture 4).
4. Note do not mix old and new batteries.
Slide
Press
12

7
Push and slide
Push and slide
34
AA Battery
AA Battery AA Battery
FCC Information

8
Tel : [phone]
U. S. Patent NO.
D724458; D724,458S