SSV Works DF-F65 User manual

DF-F65
Can-Am Defender
6.5” Front Kick Panel Speaker Enclosures
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: [phone] | Fax: [phone]
!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in
material or workmanship. All SSV Works Electronics are covered by a limited 1 year
warranty against defects in material or workmanship. Labor for replacement of defective
components is not covered. All SSV Works Speakers are covered by a limited 1 year
warranty against defects in material or workmanship. Contact SSV Works for further
warranty information.
TOOLS NEEDED FOR INSTALLATION
PARTS LIST IMAGES
1. DF-F65 Enclosures (1 pair) 3. Driver Side Drill Template 4. Passenger Side Drill
Template
2. M6 x 16mm Screws and
Washers x 2
- T30 Torx Driver - 1/8” Drill Bit
DEFENDER F65 DRIVER SIDE
DRILL TEMPLATE
DEFENDER F65 DRIVER SIDE
DRILL TEMPLATE
A. Remove the (2) bolts in the driver/pass footwell (circled in
pink) with a 10mm wrench and T30 torx driver.
(View from front fender wheel well)
B. Cut out the (Driver/Passenger) template along the cut line.
Position the template on the inside footwell and reinstall the
(2) factory bolts previously removed through the template.
Using a scribe tool, mark the center of the 3rd drill point
illustrated on the template as shown in photo.
A B
- 1/4” Drill Bit - 10mm Wrench - Scribe Tool

DF-F65 © 2018 SSV Works, Oxnard, CA 93030 DF-F65 Rev. C 10-5-18
C. Remove the factory bolts and template and drill a 1/8” pilot
hole at the points just marked with a scribe tool.
E. Place enclosure in location for mounting. Re-use the (2)
factory T30 torx screws and SSV provided M6 screws and
washers. to mount the pod loosely. Once all screws have been
loosely installed, tighten down by hand.
D. Drill a 1/4” hole through the pilot hole for mounting the pod.
F. Route the speaker wire away from any moving parts and any
sharp metal, then connect to the amplier. Connecting the
DF-F65 using the pre-installed, two-pin connector will require
an optional SSV Works plug-&-play harness (WP-H1149 -
sold separately). If you are not using the WP-H1149 harness,
simply cut off the two-pin connector and follow the wiring
instruction below.
C
E
D
F
WIRING INSTRUCTIONS
For proper sound, ensure the speaker polarity is correct connect
the “+” to the “+” and the “-“to the “-“from the speaker wire to the
amplier. If using with an SSV Works complete system refer to the
amplier wiring instructions for more detailed wiring information.
“+”
“+”
“ - ”
“ - ”

DEFENDER F65 DRIVER SIDE
DRILL TEMPLATE

DEFENDER F65 PASS SIDE
DRILL TEMPLATE