Acoustic Energy 101 User manual

www.acoustic-energy.co.uk
OWNERS MANUAL
1SERIES
ONE

Congratulations on choosing the Acoustic Energy 1 Series,
speakers designed to oer extremely high performance and
technical ability.
The 1 Series has been engineered to oer neutral balance, low-
distortion and high power handling with as little cabinet
colouration as possible. Combined with discreet front-porting,
the 1 Series are extremely exible loudpeakers for use in any
room or position in the modern home.
Please take a little time to read through this manual and follow,
as far as practical, the installation guidelines it contains.
Careful installation will help ensure your 1 Series speakers
perform optimally and oer many years of listening enjoyment.
Should you have any questions not covered here or need more
in-depth set-up advice we are happy to try and answer your
queries either by telephone or email. Contact information can
be found on the back of this manual.

Congratulations on choosing the Acoustic Energy 1 Series,
speakers designed to oer extremely high performance and
technical ability.
The 1 Series has been engineered to oer neutral balance, low-
distortion and high power handling with as little cabinet
colouration as possible. Combined with discreet front-porting,
the 1 Series are extremely exible loudpeakers for use in any
room or position in the modern home.
Please take a little time to read through this manual and follow,
as far as practical, the installation guidelines it contains.
Careful installation will help ensure your 1 Series speakers
perform optimally and oer many years of listening enjoyment.
Should you have any questions not covered here or need more
in-depth set-up advice we are happy to try and answer your
queries either by telephone or email. Contact information can
be found on the back of this manual.

Positioning
The 1 Series are very exible with regard to positioning and are
designed to work well wherever they are located within the listening
environment. There are however some basic guidelines that should
be followed (where possible) for optimum performance:
The tweeters (high frequency drivers, N/A to subwoofer) should ideally
be at ear level when the listener is seated and for serious listening the
grilles are best removed where practical. The 107 may require
placement lower if used with a screen in typical A/V layout.
Rigid support is necessary for the speakers to deliver optimum
dynamic response and detail, the 101’s and 107 benet from either
good stands or a solid surface below them, the 103’s and 108 should
be used with their own oor spikes where possible. Extra coupling can
be achieved with standard mounting tack used to secure placement.
Room positioning: The 1 Series speakers are all“room-friendly”models
and should be able to be placed where most convenient with minimal
detriment to sound. Where possible a minimum of 6”(15cm) of space
should be allowed between the speakers and boundary walls. Stereo
models should be the same distance from each other as the listening
position.
Experiment and listen to what works best for you, trust your own ears
and judgement.

Positioning
The 1 Series are very exible with regard to positioning and are
designed to work well wherever they are located within the listening
environment. There are however some basic guidelines that should
be followed (where possible) for optimum performance:
The tweeters (high frequency drivers, N/A to subwoofer) should ideally
be at ear level when the listener is seated and for serious listening the
grilles are best removed where practical. The 107 may require
placement lower if used with a screen in typical A/V layout.
Rigid support is necessary for the speakers to deliver optimum
dynamic response and detail, the 101’s and 107 benet from either
good stands or a solid surface below them, the 103’s and 108 should
be used with their own oor spikes where possible. Extra coupling can
be achieved with standard mounting tack used to secure placement.
Room positioning: The 1 Series speakers are all“room-friendly”models
and should be able to be placed where most convenient with minimal
detriment to sound. Where possible a minimum of 6”(15cm) of space
should be allowed between the speakers and boundary walls. Stereo
models should be the same distance from each other as the listening
position.
Experiment and listen to what works best for you, trust your own ears
and judgement.
Connections (101 and 103*)
Check that your amplier is switched o before installing your
loudspeakers. Failure to do so may result in speaker or amplier
damage.
The positive cable from the amplier positive (or red) terminal should
connect with the positive (red) terminal on the loudspeaker. Similarly
the negative cable should connect the amplier negative terminal
(black) to the negative terminal (black) on the loudspeaker.
After wiring up, lower the volume to the minimum, switch on the
amplier, select the signal source and then raise the volume to the
listening level required.
*For 107 and 108 models please refer to amplier instruction manual
as many congurations are possible and will vary.
-+
Amplier (Rear)
- + - +
- +
Speaker
(Rear)
- +
Speaker
(Rear)
(diagram for illustration purposes only)

Specications
Tweeter: 28mm AE Custom Fabric Dome (108 N/A)
Mid/Bass Drivers: 101,103,107 = 110mm Anodised Aluminium Cones
108 = 200mm Recycled Pulp Fibre Cone
Power Handling: 101 = 150 Watts RMS, 103 = 175 Watts RMS
107 = 175 Watts RMS, 108 = Active 150 Watts
Frq Response: 101 = 48Hz-32kHz, 103 = 40Hz-32kHz
107 = 45Hz-32kHz, 108 = 38Hz-120Hz (+/- 3dB)
Sensitivity: 101 = 87dB, 103 = 89dB, 107 = 88dB (108 N/A)
Impedance: 8 ohm (6 ohm minimum) All models (108 N/A)
Cabinet: Multiple brace, pressure loaded 18mm MDF
with low turbulence slot ports, 108 Sealed box.
Weight (Each): 101 = 6kg, 103 = 14kg, 107 = 9kg, 108 = 10kg
Size (HxWxD): 101 = 230 x 150 x 200mm, 103 = 730 x 150 x 270mm
107 = 150 x 400 x 200mm , 108 = 280mm³
Finish: Black Ash, Walnut or High Gloss White vinyl.

Specications
Tweeter: 28mm AE Custom Fabric Dome (108 N/A)
Mid/Bass Drivers: 101,103,107 = 110mm Anodised Aluminium Cones
108 = 200mm Recycled Pulp Fibre Cone
Power Handling: 101 = 150 Watts RMS, 103 = 175 Watts RMS
107 = 175 Watts RMS, 108 = Active 150 Watts
Frq Response: 101 = 48Hz-32kHz, 103 = 40Hz-32kHz
107 = 45Hz-32kHz, 108 = 38Hz-120Hz (+/- 3dB)
Sensitivity: 101 = 87dB, 103 = 89dB, 107 = 88dB (108 N/A)
Impedance: 8 ohm (6 ohm minimum) All models (108 N/A)
Cabinet: Multiple brace, pressure loaded 18mm MDF
with low turbulence slot ports, 108 Sealed box.
Weight (Each): 101 = 6kg, 103 = 14kg, 107 = 9kg, 108 = 10kg
Size (HxWxD): 101 = 230 x 150 x 200mm, 103 = 730 x 150 x 270mm
107 = 150 x 400 x 200mm , 108 = 280mm³
Finish: Black Ash, Walnut or High Gloss White vinyl.
Warranty
Your Acoustic Energy 1 Series loudspeakers are guaranteed against original
defects in materials, manufacture and workmanship for 3 years (108 Subwoofer
1 year) from the date of Purchase. Please retain all original packaging materials
for possible future use.
We suggest that you complete the details of purchase now and keep this
information in a safe place for future reference.
Under this warranty Acoustic Energy agrees to repair any defect or, at the
company’s discretion, replace the faulty component(s) without charge for
parts or labour. This warranty does not imply any acceptance by Acoustic
Energy or its agents for consequential loss or damage and specically excludes
fair wear and tear, accident, misuse or unauthorised modication.
This warranty is applicable in the United Kingdom only and does not in any
way limit the customer’s legal rights. Claims and enquiries under the warranty
for AE products purchased outside the UK should be addressed to the local
importers or distributors.
If you have reason to claim under the warranty please contact your dealer in
the rst instance.
Dealer’s name: ...............................................................................................................................
Date of purchase: .........................................................................................................................
Serial numbers: .............................................................................................................................

www.acoustic-energy.co.uk
ACOUSTIC ENERGY LTD
16 Bridge Road,
Cirencester,
Gloucestershire,
GL7 1NJ
Tel: [phone]
Fax: [phone]
Email: [e-mail]