ACTON BLINK BOARD User manual

ACTON
BLINK® BOARD
（Belt Drive）
OWNER’S MANUAL
CONTENTS
I. SAFETY WARNINGS
A. General Disclaimer
B. Age, Weight & Health
C. Conditions for safe riding
D. Battery Handling & Disposal
E. Radio Interference Precautions
II. PRODUCT INFORMATION
A. Technical Specifications
B. Parts List
C. Available Accessories/Service Components
III. USING BLINK®
A. Riding & Beginner Tips
B. Low Battery Warning/ Charging
C. Sleep mode
IV. CARE & MAINTENANCE
A. Belts, Bearings & Wheels
B. Other maintenance
V. TROUBLESHOOTING
VI. WARRANTY
VII. COPYRIGHT
WARNING!
RISK OF DEATH OR SERIOUS INJURY MAY OCCUR
WEAR HELMET AND PROTECTIVE GEAR AT ALL TIMES
Improper use of ACTON Blink® can lead to serious injury or even death due to loss
of control, falls and collisions. Please read and follow all instructions in this Owner’s
Manual prior to using Blink®.
DO NOT RETURN TO STORE! PLEASE CONTACT US DIRECTLY FOR
TECHNICAL SUPPORT BY SENDING AN EMAIL TO:
[e-mail]
NOTE: Manual illustrations are for demonstration purposes only. Illustrations may
not reflect exact appearance of actual product. Specifications are subject to
change without notice.
1

Do not use ACTON Blink® until you read and thoroughly un-
derstand the Owner’s Manual. It contains information that is
critical to your safety.
ACTON is not liable for any damage or injury caused by un-
safe usage or faulty repairs. Any repairs made to this product
by unauthorized service technicians are the sole responsibil-
ity of the owner.
Blink® is only for people 16 years of age and older.
Always wear protective gear including knee, elbow, and wrist
guards and an approved safety helmet when riding Blink®.
Only use Blink® on paved surfaces or on gentle slopes. Do
not use on dirt, sand, steep slopes, or slippery surfaces. Use
caution when going down hills.
IMPORTANT
2

I. SAFETY WARNINGS
A. General Disclaimer
Riding ACTON Blink® can be a dangerous activity. Certain conditions may cause the
equipment to fail without fault of the manufacturer. Like other electric transportation
products, ACTON Blink® is intended to move and accordingly it is possible for the rider
to lose control, fall, collide with other objects, and/or get into dangerous situations
that no amount of care, instruction or expertise can completely eliminate. If such things
occur you can be seriously injured or die, even when using safety equipment and using
other precautions.
RIDE AT YOUR OWN RISK AND USE COMMON SENSE.
This manual contains many warnings and cautions concerning the consequences of
failing to maintain, inspect or properly use your ACTON Blink®. Because any incident
can result in serious injury or even death, we repeat the warning of possible serious
injury or death.
WEAR HELMET AND PROTECTIVE GEAR AT ALL TIMES.
B. Age, Weight & Health
ACTON Blink® is designed for adults and for older teens. The recommended rider age
is 16 years of age and older. Keep ACTON Blink® away from small children and young
teens.
DO NOT EXCEED THE WEIGHT LIMIT OF 220 LBS.
C. Conditions for safe riding
where ACTON Blink® may be used. Ride defensively. Watch out for potential obstacles
that could catch your wheels, force you to swerve suddenly, or lose control. Be careful
to avoid pedestrians, inline skaters, motor vehicles, other skateboarders, scooters,
bikes, children or animals that may enter your path.
Always wear proper protective equipment such as an approved safety helmet (with
chin strap securely buckled), wrist guards, elbow pads, and kneepads. A helmet may be
legally required by local law or regulations in your area. A long-sleeved shirt and long
pants are recommended. Before riding, be sure to check that all wheels, trucks and the
battery case are secured properly.
WARNING: AVOID WATER
ACTON Blink® is not water-proof. Do not ride in the rain, wet or icy weather, as the
electrical and drive components could be damaged. Always ride on dry,paved surfaces.
The side LEDs on Blink® are only decorative, not illuminating lights. Do not ride Blink®
at night, or when visibility is limited.
NO TRICKS
Do not attempt or do stunts or tricks on your Blink®. Blink® is not made to withstand
abuse from misuse such as jumping, curb grinding or any other types of stunts. Blink®
can break from the stresses incurred by these activities. Any such misuse will void the
warranty.
D. Battery Handling & Disposal
Your Blink® may not have a fully charged battery when first received. Accordingly, you
should charge the battery prior to your first use. Battery is best used under optimal
conditions: temperature 50-75F (10-24C), absolute humidity 45-85%.
NO RIDING AT/BELOW FREEZING TEMPERATURE
Never store or use the battery in freezing or below freezing temperatures.
3

drain the battery. When the battery is drained, it is VERY susceptible to damage.
When the Blink® is not in regular use, recharge the battery at least once a month until
normal use is resumed.
Use only the recommended charger and use caution when charging. The charger
should be regularly examined for possible damage to the cord, plug, enclosure or other
parts. The charger should be operated only by an adult. Do not operate the charger
near flammable materials. Unplug the charger and disconnect from Blink® when not in
use and charging is complete.
E. Radio Interference Precautions
ACTON Blink® incorporates a sophisticated communication system to ensure
connection between the remote controller and the skateboard. The connection could
be unstable or lost when the remote controller’s battery is low. Stop riding when the
remote’s low battery warning appears.
Try to avoid areas with high-power electromagnetic radiating equipment, such as
radio towers, powerlines or radar. In some rare cases, connection may also be lost
when the connection is lost. If a loss of connection happens more than once, stop use
immediately and avoid using Blink® again in such a reason.
Please contact ACTON for further assistance.
II. PRODUCT INFORMATION
A. Technical Specification
B. Part List
• Blink® electrical skateboard
• Remote controller
• Skateboard Charger
• Skateboard Key (Tool)
• Blink® Strap
4
Deck 26.8 inches long, Canadian Maple
Wheels 83mm, 78A hardness
Weight 9 lb./ 4 kg.
Max Speed 15 mph/ 24 kmph
Range 6 miles/ 9.5km
Max Incline Rate 15%
Max Rider Weight 220lb./ 100kg.
Power 800 Max Power
Battery Capacity 72 Wh
Charging Time 1 hour
Remote Controller 2.4Ghz Bluetooth
Run time: Up to 45 min
Recharge time: 1 hour
®
®

C. Available Accessories/ Service Components
• Belt
• Wheel sets (3 passive wheels + 1 driving wheel, not including bearings)
• Driving wheel (not including bearings)
• Wheel bearing sets (8 bearings)
• Blink™ Strap
• ACTON Helmet
III. USING BLINK®
A. Riding & Beginner Tips
The following is a quick start guide for experienced skateboarders.
The remote is provided to control the acceleration and speed.
There are three modes for Blink®: BEGINNER, NORMAL and PRO. You may change the
modes from the App. Please download the app “ACTON” to your phone. Currently we
only o er the app for Android 4.3+ and iOS iPhone 5+. For your safety, please set to
BEGINNER mode on the app home page to start with. Only set to NORMAL mode when
you are a comfortable rider. Only set to PRO mode when you are very familiar with the
BLINK®
WARNING: The throttle is sensitive. YOU MUST USE THROTTLE GENTLY TO AVOID
GETTING THROWN OFF!
5
Left or Right= On

6
Also, follow these tips:
• Start by moving forward as slowly as possible
• Push the throttle in small increments.
• Keep a wide stance on the board
• Lean forward when accelerating.
• While braking, pull the throttle backward gently
B. Low Battery Warning/ Charging
When battery is low, a small speaker from the skateboard will beep several times as
a warning. However, sometimes you may not hear that sound. It is recommended to
ride carefully when you feel the motor is weak as it may shut down automatically. In
such cases, stop using Blink® and charge it with the provided charger.
The same beeping sound will come from the remote control when the battery is low
in the remote control. In the event that it does, stop using Blink® immediately as
riding performance can be extremely unpredictable while the remote tries to stay
connected to the board while the battery charge depletes.
ALWAYS CHARGE THE BATTERY AFTER IT DRAINS.
The battery must get charged immediately after it drains for long term battery
longevity. If the state of charge is allowed to remain below minimum for too long, it
may not be able to be recharged.
Red = Charging
Red = Charging
Charging the skateboard is indicated by the LED indicator on the charger. The LED
will turn from red to green as it finishes charging. Charging the remote controller is
C. Sleeping mode
Blink® includes an energy saving mode- sleep mode-to prevent the battery from dying
if the user forgets to turn it o. After the system keeps idle for 5 minutes, both the
remote and the skateboard will go into energy saving/sleep mode. To reconnect the
two, both the board and the remote will have to be turned o. Do not alternate turning
them o and back on- make sure they are both o together and then turn them back on
after at least five seconds of o time.
the board is in normal operating mode or sleep mode. If the board remains on, the
battery charge will deplete.

IV. CARE &MAINTENANCE
A. Belts, Bearings and Wheels
Belts, Bearings and Wheels may require frequent service depending on how heavily
Blink® is ridden. Gene rally, these components will not be included in the warranty. You
Here is a step list about changing the driving wheel and the belt:
(1) Loosen the axle nut using the provided skateboard tool
(2) Pull out and rotate the driving wheel.
Warning: Keep an eye on all the spacers. Don’t lose them!
(3) Unscrew the cap screws and change belt.
(4) Put everything back into position
WARNING: Do not overtighten the axle nut or you can damage the bearing shields.
Tighten just to the point where the wheel can no longer laterally move along the axle.
B. Other maintenance
Clean the surface of Blink® with a damp, but not overly wet, soft cloth only. Store
Blink® in an indoor and cool environment. Recharge the battery at least once per
month and avoid contacting with volatile liquids including Alcohol or strong cleaning
agents.
7

V. TROUBLESHOOTING
If your Blink® is not running properly, stop using it immediately. In most cases, turning
problems or restarting the Blink® doesn’t resolve the issue, refer to the following chart
for common troubleshooting methods. If the problem still exists, please stop using the
Blink® and contact ACTON.
VI. WARRANTY & DISCLAIMER
Return Policy
We gladly accept returns of unused product in original package within 7 days from your
purchase date with full refund to the original payment method. Products must be in store
bought condition with packaging in new, sellable form to be returned or exchanged.
Copy of receipt from ACTON online store is required. ACTON product purchased through
one of our authorized resellers are subject to the reseller’s policies.
Warranty
This warranty is non-transferrable, and applies only to the original purchaser of ACTON
roducts. Your ACTON product has limited coverage for 6-months from the date of
purchase by the original purchaser from the ACTON online store or authorized resellers
ONLY. A copy of the receipt from the ACTON online store or ACTON authorized reseller
must be provided.
ACTON provides 90 days from date of purchase or 200 miles (whichever comes first)
manufacturer warranty for any manufacturing defects or workmanship. Please reach out
to [email protected] with a copy of the receipt. Mileage can be retrieved via the
ACTON APP, under your profile page. ACTON will cover shipping cost both ways under
this warranty category; repairs or replacement—to be determined by ACTON—will be free
of charge.
From 91 days to 6 months or 201 to 400 miles, ACTON warrants the motors free from any
manufacturing defects. The end-user is responsible for shipping costs of the defective
product sent to ACTON; ACTON will be responsible for repairs or replacement, as well as
shipping back to the end-user.
8
Symptom Probable Cause Solution
Won’t turn on Low Battery Charge battery for at least 1 hour
Won’t go Bluetooth not connected Restart the remote and skate-
board
Skateboard/remote in sleep
mode
Shutdown both for 10 seconds
then turn on again
Won’t charge Charger not connected Make sure you’re using the correct
charger and that it is properly
connected to an outlet
Battery depleted If battery has not been charged
for more than one month, it may
require an extra hour before it
takes a charge
Range too low Exceed the weight limit Blink is designed for a person who
weighs up to 220lbs
Battery health dropped May need to replace the battery
pack
vibration and noises Belt is loose Change belt
Wheel/Bearing has worn down Change wheel/bearing

VII. COPYRIGHT
Please visit www.ACTONglobal.com for the most up-to-date copyright information.
ACTON
1172 Castro Street,
Mountain View, CA 94040
[e-mail]
ACTON products that have suered damage stemming from an accident or impact, have
been exposed to abuse, and that have visible evidence of damage as a direct result of
impact with other objects, or have been exposed to water, negligence (such as, but not
limited to leaving batteries discharged for extended periods of time) will NOT be covered.
Parts such as bearings, belts, wheels, tires, grip tape, and bushings are considered
consumables and wear under normal conditions. They are not covered by warranty. The
use of any alternate charger will void this warranty. Any unauthorized alterations,
tampering or repairs are not covered by this warranty.
9