Actron CP9180 User manual

1
CP9180
USB Driver Installation Instructions
1. Plug the tool into an available USB Port, power the tool on, and put the
tool in program mode (See user manual for program mode instructions)
WINDOWS ME:
2. Open Windows “Control Panel” and *double-click* on the “System” icon
3. Click on “Device Manager” and proceed to step 4
WINDOWS XP:
2. *Right-click* on your My Computer icon and select Manage from the drop
down list

CP9180 – USB Driver Installation Instructions
2
3. In the left-hand side of the Computer Management window, click Device
Manager
4. In the right-hand column, *double-click* USB Device. This should be
located under the Other Devices icon or the Universal Serial Bus
controllers icon. Then, click Reinstall Driver or Update Driver.
**There is usually a yellow question mark or exclamation mark next to the icon and it is usually
located under the “Other Devices” folder. If you have trouble locating the icon, reinsure that your
tool is plugged in and powered on.

CP9180 – USB Driver Installation Instructions
3
5. Highlight the bullet next to Yes, this time only and click Next >
6. Highlight the bullet next to Install from a list or specific location
(advanced) and click Next >.

CP9180 – USB Driver Installation Instructions
4
7. Highlight the bullet next to Search for the best driver in these locations,
check the box next to Include this location in the search, and click
Browse
8. Browse for C:\Program Files\ScanningSuite\Actron\Drivers and click
OK.

CP9180 – USB Driver Installation Instructions
5
9. Ensure the correct location is in the text box and click Next >
10.The Windows New Hardware Wizard will begin searching for the USB
Cable Driver.
**If a warning appears stating the software you're installing has not passed windows logo testing
click Continue Anyway.

CP9180 – USB Driver Installation Instructions
6
11. When the files are done downloading click Finish
12.Your drivers are now installed and you can continue with Scanning Suite
operation.
2008 SPX. All rights reserved.