ACU-RITE DRO30 Series User manual

Changing the Count Direction
on a DRO203 & DRO30X

Changing the Count Direction
on a DRO203 & DRO30X
Note which port the encoder you
need to change is plugged into. You
will need this information for later.

Changing the Count Direction
on a DRO203 & DRO30X
Power up the box.
When prompted,
press any key to
continue.
The power switch is located on the back,
directly under the power cord.

Changing the Count Direction
on a DRO203 & DRO30X
Reference your
encoders by
moving each axes
so they cross at
least 2 reference
marks on the
glass (~3“).

Changing the Count Direction
on a DRO203 & DRO30X
Use the left or
right arrow keys to
change the soft
key menu below
the screen, until
you find the Setup
menu.

Changing the Count Direction
on a DRO203 & DRO30X
Press the Setup
soft key.

Use the up and
down arrow keys
to highlight the
User Management
menu, then press
enter.
Changing the Count Direction
on a DRO203 & DRO30X

Use the up and
down arrow keys
to highlight the
Supervisor Login
menu, then press
enter.
Changing the Count Direction
on a DRO203 & DRO30X

Using the number
keypad to enter
the passcode –
8891, then press
enter.
Changing the Count Direction
on a DRO203 & DRO30X

Use the left arrow
key to return to
the Configuration
Menu.
Changing the Count Direction
on a DRO203 & DRO30X