ACU-RITE 06034 User manual

Sell Empty1n9
Instruction Manual
Rain Gauge
model 06034
Package Contents
1. Rain Gauge
2. Mounting Hardware
3. Instruction Manual
PRODUCT MUST BE REGISTERED
IMPORTANT TO RECEIVE WARRANTY SERVICE
PRODUCT REGISTRATION
Register online to receive 1 year warranty protection
www.AcuRite.com
Questions? Contact Customer Support at
[phone] or visit www.AcuRite.com.

Features & Benets
1
2
3
4
RAIN GAUGE
1. Rain Gauge Cover
2. Rain Gauge Tipping Cups
Collects and empties rain for
continuous rain measurement.
3. Battery Compartment &
Electronics Box
A B C
SQUEEZE
5
4. Rain Gauge Base
5. A-B-C Switch
ID code that must match
companion unit's A-B-C switch
(if applicable) to ensure units
synchronize.
2

• • -
SQUEEZE
SQUEEZE
LARGE
TABS
SQUEEZE
LARGE
TABS
SQUEEZE
SQUEEZE
LARGE
TABS
SQUEEZE
LARGE
TABS
1
SETUP
Install or Replace Batteries
AcuRite recommends high quality alkaline batteries for the best product
performance. Heavy duty or rechargeable batteries are not recommended.
SQUEEZE
LARGE
TABS
SQUEEZE
LARGE
TABS
SQUEEZE
SQUEEZE
LARGE
TABS
SQUEEZE
LARGE
TABS
2
SQUEEZE
SQUEEZE
LARGE
TABS
SQUEEZE
LARGE
TABS
3 4
Rain Collector
1. Separate rain collector cover from the base by gently
squeezing tabs and pulling the cover upwards.
2. Remove battery box by squeezing the two tabs on
each end together.
3. Remove and discard cardboard rain gauge stabilizer.
4. Insert 2 x AA batteries into the battery compartment
as shown. Follow the polarity (+/-) diagram in the
battery compartment.
5. Securely place the battery box back into the rain
collector base.
6. Securely re-attach the rain collector cover onto rain
collector base.
5
SQUEEZE
SQUEEZE
LARGE
TABS
SQUEEZE
LARGE
TABS
6
Set the A-B-C Switch
If you are syncing sensor with a
display (not included), ensure that the
A-B-C switch, located in the battery
compartment, matches on both units.
A-B-C Switch
A B C
3

Placement for Maximum Accuracy
AcuRite sensors are sensitive to surrounding environmental conditions. Proper placement
of the rain collector is critical to the accuracy and performance of this product.
Important Placement Guidelines
• Companion unit and rain collector must be within 100 ft (30 m) of each other.
• To maximize wireless range and communication, install the rain gauge at least 3 ft (.9 m)
above ground. Place the rain gauge away from large metallic items, thick walls, metal
surfaces, or other objects that may limit wireless communication.
• To prevent wireless interference, place the collector at least 3 ft (0.9 m) away from
electronic devices (TV, computer, microwave, radio, etc.)
TV 3
100 feet maximum
AT
LEAST
APART
COMPANION
UNIT
(30 meters)
Rain Collector Installation
• To ensure accurate rain measurement, the rain collector MUST be placed on a at,
level surface.
• Ensure the rain collector is not placed in a low spot that could become ooded or in
an area where there are obstructions above it.
OK
1. Separate the rain collector cover from the rain collector base.
2. Locate the two holes on the rain collector base.
3. Fasten the rain collector base to a sturdy surface, like a deck railing or a fence post,
with screws (included) using hand tools. (Power tools may slip during installation,
causing damage to the rain collector.)
INSTALL 2 SCREWS USING
HAND TOOLS ONLY.
THEN RE-ATTACH UPPER CASING
SQUEEZE
SQUEEZE TABS TO OPEN
4

Troubleshooting
Rainfall registering
when there’s
no rain
• Make sure the rain collector is mounted securely so
that it cannot move or sway in the wind. The rain
collector should be mounted on a solid and level
surface in a clear area away from any overhead
obstructions that may block rainfall.
• Make sure you are using standard alkaline batteries
(not heavy duty, max or rechargeable).
Can the rainfall collector
remain outdoors in
freezing temperatures?
No, the rainfall collector should be brought indoors when
there is a possibility of freezing temperatures. Water
expands when it freezes. If any water is left within the
collector during a freeze, it can crack the plastic and
cause permanent damage.
Calibration
Calibrate the Rain Gauge
The rain gauge can be calibrated to improve accuracy.
Items Needed: rain collector, companion unit, plastic cup, pin, screw driver
1. First, place the rain collector on a level surface.
2. Place the companion unit (i.e. display) close by so you can monitor it during calibration.
3. Make a pin hole in the bottom of a plastic cup. Hold the cup over the rain gauge
and ll it with exactly 1 cup (8 oz.) of water, allowing the water to slowly drip into
the rain gauge. You should hear the internal cups tipping and see the water drain
through the rain gauge.
4. A few seconds after each cup tip, the companion unit will display rainfall in
approximately 0.01”
(0.2 mm) or more increments.
5. The cup of water should take more than 20 minutes to empty; a quicker period will
result in an inaccurate calibration. Try to simulate a normal steady rainfall. When
the cup is empty of water, the companion unit should register 1.68”
(42.67 mm).
Tips
• There should be nearly an equal number of water drops between cup tips. If not,
then adjust the calibration screws beneath the tipping lever until an equal number of
water drops are tipping the cups. Then, restart the calibration procedure.
• If you don’t hear the cups tipping and see water dripping alternately out of each
drain, there may be an issue with the rain gauge or it’s adjustment.
Adjustment
If the rain gauge doesn’t register close to 1.68” (42.67 mm)
after the cup is empty, make an EQUAL adjustment to the two
calibration screws, located beneath the tipping cups. Turn
screws counter-clockwise to increase rainfall; turn screw
clockwise to decrease rainfall.
• To adjust the rainfall reading by 2% turn both
screws 1/4 of a turn.
• To adjust the rainfall reading by 4% turn both
screws 1/2 of a turn.
• To adjust the rainfall reading by 8% turn both
screws 1 full turn. 2 CALIBRATION SCREWS
COLLECTING CUP
Increase
Rainfall
Decrease
Rainfall
Increase
Rainfall
Decrease
Rainfall
5

Care & Maintenance
Rain Collector Care
Clean with a soft damp cloth. Do not use caustic cleaners or abrasives that
could mar the polished surface of the rain collector or tipping cups. If the
collector becomes dirty, rain water may not ow correctly through the rain
collector. Some environmental conditions may require more frequent, periodic
cleaning of the collector. After a cleaning, it is recommend to apply a small
amount of liquid water repellent (found in the automotive section) to the tipping
cups and collector funnel for optimal rain collection.
The rainfall collector cannot be used in the winter during freezing temperatures.
Water expands when it freezes. If any water is left within the unit during a
freeze, it can crack the plastic and permanently damage the unit.
Specications
RAINFALL MEASUREMENT 0.01 inches (0.25 mm) and up
WIRELESS RANGE 100 ft / 30 m depending on home construction materials
WIRELESS FREQUENCY 433 MHz
POWER 2 x AA alkaline batteries
DATA REPORTING 60 second updates
FCC Information
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modications to this equipment.
Such modications could void the user authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.
6

Q)
Customer Support
AcuRite customer support is committed to providing you with best-in-
class service. For assistance, please have the model number of this
product available and contact us in any of the following ways:
[phone]
Visit us at www.AcuRite.com
► Installation Videos ► Register your Product
► Instruction Manuals ► Support User Forum
► Replacement Parts ► Submit Feedback & Ideas
PRODUCT MUST BE REGISTERED
IMPORTANT TO RECEIVE WARRANTY SERVICE
PRODUCT REGISTRATION
Register online to receive 1 year warranty protection
www.AcuRite.com
Limited 1 Year Warranty
AcuRite is a wholly owned subsidiary of Chaney
Instrument Company. For purchases of AcuRite
products, AcuRite provides the benets and services set
forth herein. For purchases of Chaney products, Chaney
provides the benets and services set forth herein.
We warrant that all products we manufacture under this
warranty are of good material and workmanship and, when
properly installed and operated, will be free of defects for a
period of one year from the date of purchase.
Any product which, under normal use and service, is proven
to breach the warranty contained herein within ONE YEAR
from date of sale will, upon examination by us, and at our sole
option, be repaired or replaced by us. Transportation costs and
charges for returned goods shall be paid for by the purchaser.
We hereby disclaim all responsibility for such transportation
costs and charges. This warranty will not be breached, and we
will give no credit for products which have received normal
wear and tear not affecting the functionality of the product,
been damaged (including by acts of nature), tampered,
abused, improperly installed, or repaired or altered by others
than our authorized representatives.
Remedy for breach of this warranty is limited to repair or
replacement of the defective item(s). If we determine that repair
or replacement is not feasible, we may, at our option, refund
the amount of the original purchase price
THE ABOVE-DESCRIBED WARRANTY IS THE SOLE WARRANTY
FOR THE PRODUCTS AND IS EXPRESSLY IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED. ALL OTHER WARRANTIES
OTHER THAN THE EXPRESS WARRANTY SET FORTH HEREIN
ARE HEREBY EXPRESSLY DISCLAIMED, INCLUDING WITHOUT
LIMITATION THE IMPLIED WARRANTY OF MERCHANTABILITY
AND THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR
PURPOSE.
We expressly disclaim all liability for special, consequential,
or incidental damages, whether arising in tort or by contract
from any breach of this warranty. Some states do not allow the
exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you.
We further disclaim liability from personal injury relating to
its products to the extent permitted by law. By acceptance of
any of our products, the purchaser assumes all liability for the
consequences arising from their use or misuse. No person, rm
or corporation is authorized to bind us to any other obligation
or liability in connection with the sale of our products.
Furthermore, no person, rm or corporation is authorized
to modify or waive the terms of this warranty unless done in
writing and signed by a duly authorized agent of ours.
In no case shall our liability for any claim relating to our
products, your purchase or your use thereof, exceed the
original purchase price paid for the product.
Applicability of Policy
This Return, Refund, and Warranty Policy applies only to
purchases made in the United States and Canada. For
purchases made in a country other than the United States or
Canada, please consult the policies applicable to the country in
which you made your purchase.
Additionally, this Policy applies only to the original purchaser
of our products. We do cannot and do not offer any return,
refund, or warranty services if you buy products used or from
resale sites such as eBay or Craigslist.
Governing Law
This Return, Refund, and Warranty Policy is governed by the
laws of the United States and the State of Wisconsin. Any
dispute relating to this Policy shall be brought exclusively in the
federal or State courts having jurisdiction in Walworth County,
Wisconsin; and purchaser consents to jurisdiction within the
State of Wisconsin.
7

ACU ► RITE®
ACU ► RITE.
Weather Temperature Weather Kitchen Clocks
Stations & Humidity Alert Radio Thermometers
& Timers
It’s More than Accurate, it’s
AcuRite offers an extensive assortment of precision instruments,
designed to provide you with information you can depend on to
Plan your day with condence™.
www.AcuRite.com
©Chaney Instrument Co. All rights reserved. AcuRite is a registered trademark of
the Chaney Instrument Co., Lake Geneva, WI 53147. All other trademarks and copy-
Printed in China rights are the property of their respective owners. AcuRite uses patented technology.
06034 INST 061416 Visit www.AcuRite.com/patents for details.