ADDAC System T-Networks ADDAC103 User manual

July.2019
ADDAC103 Assembly Guide
ADDAC SYSTEM page 2
Tools Needed:
Wire cutter
Pliers

ADDAC SYSTEM page 3
STEP 1:
Start by locating the 2x5 pinheader and the 78L05 regulator and solder them like shown below.
ADDAC103 Assembly Guide

ADDAC SYSTEM page 4
STEP 2:
Next locate the 2 capacitors and solder like shown below.
ADDAC103 Assembly Guide

STEP 4:
For these 2 pots, trim the middle legs like shown below.
STEP 5:
Locate the plastic shaft trim pots and flatten out their legs with the
help of some pliers, like shown below.
ADDAC SYSTEM
STEP 3:
Before placing all remaining parts we’ll have to prepare 2 metal shaft pots and the trimmer pot like
shown below.
page 5
ADDAC103 Assembly Guide

ADDAC SYSTEM
STEP 6:
After all parts are in position place the front panel and tighten the nuts like shown below.
page 6
ADDAC103 Assembly Guide

ADDAC SYSTEM page 7
ADDAC103 Assembly Guide
STEP 7:
Solder all the front parts pads.

ADDAC SYSTEM page 8
Finish it by placing the knobs and the remaining nuts and
you’re done!
Happy Patching!!
ADDAC103 Assembly Guide

For feedback, comments or problems please contact us at:
[email protected]
ADDAC103 ASSEMBLY GUIDE
July.2019Revision.01