ADDAC System ADDAC714 User manual

February.2023
ADDAC714 Assembly Guide
ADDAC SYSTEM page 2

ADDAC SYSTEM page 3
ADDAC714 Assembly Guide
STEP 1:
Start by placing the diodes, notice the orientation marked on the pcb.
STEP 2:
Place and solder the 2x5 boxed pinheader. Notice the indent orientation.

STEP 3:
Next we’ll need to prepare some parts before placing them to the front panel.
Use pliers to flatten out 2 of the pots legs like shown below
ADDAC SYSTEM page 4
STEP 4:
Locate the jacks and cut the thinest leg like shown below.
ADDAC714 Assembly Guide

Threaded Jacks
Threaded
Jacks
Non-threaded
Jacks
Non-threaded
Jacks
ADDAC SYSTEM page 5
STEP 5:
Place and all parts on the pcb, notice the difference between the jacks.
Once placed allign with the frontpanel and tighten all the nuts.
ADDAC714 Assembly Guide

ADDAC SYSTEM page 6
Keep lines parallel
ADDAC714 Assembly Guide
STEP 6:
Adjust the height of the pcb keeping it parallel to the front panel and proceed to solder all parts.

ADDAC SYSTEM page 7
Finish it by placing the knobs and you’ve finished the
assembly process!
You’re all done!
Happy patching!
ADDAC714 Assembly Guide

For feedback, comments or problems please contact us at:
[email protected]
ADDAC714 ASSEMBLY GUIDE
February.2023Revision.01