Addonics Technologies Sapphire Mobile Rack II User manual

CONTACT US
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: [phone]
www.addonics.com
Phone: [phone]
Fax: [phone]
Email: http://www.addonics.com/sales/query/
Sapphire Mobile Rack II with
USB 3.0 connection
(SMR2U30)
www.addonics.com

www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST) Phoner: 408-453-6212 Email. www. Addonics.com/support/query/
Drive Installation
1. Use the small key that comes with the unit to turn the key lock to the OPEN
position
2. Lift the handle bar and pull the drive tray out of the Sapphire unit
3. Install a 3.5” SATA hard drive into the drive tray as illustrated below
4. Carefully load the SATA hard drive into the drive tray with label side facing up.
Turn over the drive tray while pressing the drive against the bottom of the tray
5. Line up the screw holes on the hard drive with the mounting holes on the tray
and secure the drive to the tray with 4 hard drive mounting screws that come
with the Sapphire unit
6. Slide the cover back onto the tray and secure the cover by turning the securing
screw to the lock position.
7. Load the drive tray back into the Sapphire unit, push down the handle bar and
turn the key lock to LOCK position
USB connection
Connect the Sapphire Mobile Rack II to the USB port of a computer using the
included USB 3.0 cable. Power on the device and in a few moment a new hard drive
should appear in Disk Management under Windows OS. If the hard drive is already
initialized and formatted, an additional hard drive icon should show up in My
Computer.
There is no driver required in USB connection.
OVERVIEW
Front view
Rear view
USB 3.0 port
Cooling fan
Accessories
Use a Philip screw drive to
turn the securing screw on the
top cover to the open position
Slide the cover towards the
back of the tray to remove it