ADEMCO VIA-30PSE User manual

For a detailed review of the entire system, please view the Ademco Via –30PSE system manual.
Arm and Disarm
Arm:
To arm in STAY mode when you are not leaving the premises, enter your [security code] + [STAY].
To arm in AWAY mode when you are leaving the premises, enter your [security code] + [AWAY].
To arm in MAX when there is no entry delay, enter your [security code] + [MAX].
Disarm:
To disarm, enter your [security code] + [OFF].
Battery
The Ademco Via 30PSE operates on a UB 1270 battery.
Quick Guide: Ademco Via-30PSE

Loss of AC power and use of backup battery power is indicated by NO AC. or AC LOSS.
A low battery condition is indicated by BAT or SYSTEM LO BAT
For instructions on replacing your battery, please visit our Battery Replacement Page.
Bypassing Protected Areas
Bypassing a zone allows you to arm your system with certain protected areas intentionally unarmed or to
access a protected area when the system is armed.
To bypass a zone, enter your [security code] + [BYPASS] + [2 digit zone number].
To unbypass a zone, disarm the system.
Change Time and Date
To change date and time settings, enter your [security code] + [#] + [6] + [3].
Wait until time/date are displayed, then press [*] to move the cursor ahead and [#] to move back.
Enter the 2-digit hour and minute settings, i.e., [06] and [17] for 6:17.
Press [1] for PM or [2] for AM.
Continue to enter 2-digit year, month, and day settings, i.e., [15], [08], and [23] for August 23, 2015.
To exit, press [*] when the cursor is on the last digit.
Chimes and Beeps
When your system is in chime mode, a chime alert will sound three tones whenever a protected door/window
is opened.
To turn chime mode on and off, enter your [security code] + [CHIME].
Reset
To clear the display after an alarm event, enter your [security code] + [OFF] sequence twice to clear the alarm
event history.
Security Codes
Your system allows for additional users, however only the Master user can assign user codes to users.

To add a user, enter your [Master code] + [8] + [new user number] + [ 4-digit new user’s code].
To delete a user, enter your [Master code] + [8] + [user number]. Wait approximately three seconds
for the keypad to verify.
Trouble Conditions
Trouble conditions are issues that require your attention and are indicated on your panel’s display by the
word CHECK + zone number and accompanied by beeping from the touchpad.
To silence Trouble Conditions beeping, check that the zone’s protected areas are closed and secure.
For wireless sensors, check that no environmental changes have blocked the wireless sensor.
If the problem is corrected, enter your [security code] + [OFF] sequence twice.
For a list of Trouble Conditions other than CHECK, please see your Ademco Via –30PSE system manual.