ADIROffice 631-04/05 User manual

Item#631-04/05
INSTALLATION GUIDE
ULTIMATE
DROP BOX
Please read and comply with
these instructions prior to
the initial operation of the
Installation. Keep the Installation
guide for future reference or for
subsequent possessors.
4STEP
Place one steel washer onto each of the four screws provided .
Attach the correct Socket bit for the screw onto a hand driver or
an electric drill. Carefully tighten the screw all the way into the wall.
Don’t over tighten the screws or you may break off the screws or
strip out the holes.
www.adircorp.com
[e-mail]

Parts and Hardware List
Installation
1
1
2
3
2
3
5
4
6
7
Wall Mount Secure MailBox
Secure Key
STEP
STEP
STEP
Mounting Screws
Rubber Garments
Steel Washers
6. 4mm Drill Bit
Drive Bit
Used With
Mounting Screws
Use a Screwdriver to remove handle from inside of the bin door and
use provided screws to attach handle to outside of the bin door.
Use the Drilling Template provided,
Mark the 2 top holes levelly and about 51’’ to 64’’ above the floor,
or according to your desired height, then mark the bottom holes.
Use the 4mm Drill bit provided , create four Holes at least 10mm
deeper than screws provided , or about 40mm deep, if the material
is unusually hard you may need to use a rotary impact drill rather
than a standard drill to make the holes.
Call a expert if needed. Put a small amount of caulk or silicone into
each hole.