
MyDict - MyAir3 as Master with LG A/C
ELECTRICIAN INSTRUCTIONS
LG Unit
1. Install the LG indoor and outdoor unit according to LG’s instructions. Do not connect any
MyAir3 electronics.
2. If you would like to install both the LG & MyAir3 controller run the control wires to the desired
location, if you only want the MyAir3 controller on the wall connect up the LG wall controller in
the roof space it will be only be used to configure the system initially then it will be
disconnected & removed later.
3. Test the LG system completely using this LG wall controller.
4. Once testing is complete proceed to next step (Function Settings).
LG Configuration
Ensure your LG controller is set to sense from the remote “REMO”you will find this on the left of the
time (see picture below)
If your controller is not set to REMO follow the procedure below
1. Press ZONE
2. Press SETTINGS
3. Now press SENSOR to cycle between through the different settings until you get to REMO.
If you choose to install the system with both MyAir3 & LG controller you will need to set the LG
controller as SLAVE this is done by changing dipswitch S/W GR to 2.
S/W GR: 2 = LG IS SLAVE
S/W GR: 1 = LG IS MASTER