Advantech MIOe-220 Installation and operation manual

MIOe-220 Startup Manual 1
Before you begin installing your board, please make sure
that the following items have been shipped:
• 1 x MIOe-220 SBC
• 1 x Startup Manual (P/N 2006E22000)
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Note1: For detailed contents of MIOe-220, please refer
to information on the support website: http://sup-
port.advantech.com.tw/
Note2: Adobe Reader is required to view any PDF file.
Adobe Reader can be downloaded at: http://get.
adobe.com/tw/reader/otherversions/ (Adobe is
the trademark of Adobe Systems Incorporated)
MIOe-220
3 x Intel® Gigabit Ethernetel® Gigabit Ethernet
Startup Manual
General
• CPU:
- MIOe-220-L3A1E 3 x IntelR Gigabit Ethernet without
PCIe Switch
- MIOe-220-B3A1E 3 x IntelR Gigabit Ethernet with PCIe
Switch (for MIO-5250 /MIO-5251/MIO-5271)
• Chipset: IntelR 82583V Gigabit Ethernet Controller
• PCIe Switch: PLX PEX8605
• Port: 3 x RJ45
• Speed: 10/100/1000 Mbps
Mechanical and Environmental
• Dimensions (L x W x H): 102 x 83 x 33 mm
(4” x 3.2” x 1.3”)
• Weight: 0.182 kg (0.401 lb)
• Operating Temperature: 0 ~ 60° C (32 ~ 140° F)
• Operating Humidity: 0% ~ 90% relative humidity, non-
condensing
• Storage Temperature: -40° C ~ 85° C and 60° C @ 95%
RH Non-Condensing
• Power Supply: Voltage Supported by MI/O Extension
SBC
The board has a number of connectors that allow you to
configure your system to suit your application.
The table below lists the function of each of connectors.
Connectors
Lable Function
CN1 MIOe I/O Module
CN3 LAN1 RJ45
CN5 LAN2 RJ45
CN7 LAN3 RJ45
Specications Packing List
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/eplatform
For technical support and service, please visit our
support website at:
http://support.advantech.com.tw/
This manual is for the MIOe-220.
Part No. 2006E22000
Printed in China
1st Edition
January 2015
Connectors

2 MIOe-220 Startup Manual
Figure 1: MIOe-220 Connector Locations (Top Side)
Figure 2: MIOe-220 Connector Locations (Bottom Side)
Figure 3: MIOe-220 Connector Locations (Coastline)
Connector Locations

MIOe-220Startup Manual 3
Mechanical Drawing
Figure 4: MIOe-220 Mechanical Drawing (Top Side)
Figure 5: MIOe-220 Mechanical Drawing (Bottom Side)

4 MIOe-220 Startup Manual
Figure 6: MIOe-220 Mechanical Drawing (MIOe Connector)
Figure 7: MIOe-220 Mechanical Drawing (Coastline)
1. There are eight screws, six studs and two nuts inside the white box, please install the heatsink into place as per illustration
below:
Mechanical Drawing
Quick Installation Guide
33,39