AEG A18SPL User manual

A18SPL
Original instructions

Important!
It is essential that you read the instructions in this manual before assembling,
operating and maintaining the product.
Subject to technical modications.

Adjustable head
Switch trigger
Handle, insulated gripping surface
Belt clip hole
Battery port
Battery pack
Belt clip
Belt clip screw
p. 4 p. 5
p. 6
p. 5

4
2
1
2
75-100 %
50-75 %
25-50 %
0-25 %

5
2s
OFF
2s
ON
OFF
12
34
ON

6
1
2

7
TECHNICAL DATA A18SPL
Type LED spotlight
Battery voltage 18 V
Wattage 38 W
Run time with one fully charged battery (Li-ion 9.0 Ah) 12 hrs
Luminous ux (High brightness level) 3200 lm
Colour rendering index (CRI) 70
Colour temperature 5000 K
Beam angle 7.2°
Weight - excluding battery pack 0.78 kg
COMPATIBLE BATTERY PACKS (NOT INCLUDED)
L1820R
L1820S
A18FB2
L1825R
L1830R-X5
A18B4
L1840R
A18FB4
L1850R
A18FB5
L1860R
L1860R-X5
L1890R
Use AEG 18V battery and charger only
WARNING! Read all safety warnings, instructions,
illustrations and specications provided with the product.
Failure to follow all instructions listed below may result in electric
shock, re, and/or serious injury. Save all warnings and
instruction for future reference.
SPOTLIGHT SAFETY WARNINGS
The light source contained in the luminaire must only be replaced by
the manufacturer, its service agent, or a similar qualied person.
Do not direct the light beam at persons or animals, and do not stare
into the light beam yourself (not even from a distance). Staring into
the light beam may result in serious injury or vision loss.
Use only with recommended battery pack and charger. Any attempt
to use another battery pack will cause damage to the product and
could possibly explode, cause a re, or personal injury.
Do not disassemble the product.
If wrapped or in contact with fabrics, the lens can produce sufcient
heat to melt some fabrics. To avoid serious personal injury, never
allow the lens to come in contact with anything.
Do not place the product or battery pack near re or heat. This will
reduce the risk of explosion and possible injury.
To reduce the risk of injury or damage, avoid contact with any hot
surface.
Remove the battery pack before starting any work on the product.
Do not store the product in a damp or wet location, or in a location
where the temperature may reach or exceed 40°C (104°F). For
example, inside sheds, vehicles, or metal buildings in the summer.
ADDITIONAL SAFETY AND WORKING INSTRUCTIONS
Remove battery pack before storing or transporting the product.
Do not dispose of used battery packs in the household refuse or by
burning them. Take them to an appropriate disposal/collection site.
Do not store the battery pack together with metal objects (short
circuit risk).
Use only System AEG chargers for charging System AEG battery
packs. Do not use battery packs from other systems.
Never break open battery packs and chargers and store only in dry
rooms. Keep dry at all times.
Battery acid may leak from damaged batteries under extreme load
or extreme temperatures. In case of contact with battery acid wash
it off immediately with soap and water. In case of eye contact rinse
thoroughly for at least 10 minutes and immediately seek medical
attention.
SPECIFIED CONDITIONS OF USE
The spotlight is intended for general illumination. Do not use the
product in wet conditions.
Do not use the product for any other purpose.
BATTERIES
Battery packs that have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance of
the battery pack. Avoid extended exposure to heat or sunshine (risk
of overheating).
The contacts of chargers and battery packs must be kept clean.
For an optimum life-time, the battery packs have to be fully charged
after used.
To obtain the longest possible battery life remove the battery pack
from the charger once it is fully charged.
For battery pack storage longer than 30 days:
• Store the battery pack where the temperature is below 27°C
and away from moisture.
• Store the battery packs in a 30% - 50% charged condition.
• Every six months of storage, charge the pack as normal.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING! To reduce the risk of re, personal injury, and
product damage due to a short circuit, never immerse your product,
battery pack or charger in uid or allow a uid to ow inside them.
Corrosive or conductive uids, such as seawater, certain industrial
chemicals, and bleach or bleach containing products, etc., can
cause a short circuit.
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements.
Transportation of those batteries has to be done in accordance with
local, national and international provisions and regulations.
■Batteries can be transported by road without further
requirement.
■Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
When transporting batteries:
■Ensure that the battery contact terminals are protected and
insulated to prevent short circuit.
■ Ensure that the battery pack is secured against movement
within the packaging.
■ Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.

8
BATTERY PACK PROTECTION
The battery pack has overload protection that protects it from being
overloaded and helps to ensure long life.
Under extreme stress, the battery electronics turn off the product
automatically. To restart, turn the product off and then on again.
If the product does not start up again, the battery pack may have
discharged completely. Recharge the battery pack.
MAINTENANCE
WARNING! Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean
cloths to remove dirt, dust, oil, grease, etc.
WARNING! Do not at any time let brake uids, gasoline,
petroleum-based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or destroy plastic
which could result in serious personal injury.
Use only AEG accessories and AEG spare parts. Should
components need to be replaced which have not been described,
please contact one of our AEG service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the product can be ordered. Please
state the Article No. as well as the product type printed on the label
and order the drawing at your local service agents or directly at:
Techtronic Industries Australia Pty Ltd
PO Box 1065
Mount Waverley VIC 3149
Tel. no. 1300 234 797
Australia
Techtronic Industries N.Z. Limited
PO Box 12-806
Penrose AUCKLAND 1642
Tel. no. 0800 234 797 (0800 AEGPWR)
New Zealand
SYMBOLS
Read the instructions carefully before starting the
product.
CAUTION! WARNING! DANGER!
Remove the battery pack before starting any work on
the product.
Do not stare at the operating light source.
To reduce the risk of injury or damage, avoid contact
with any hot surface.
Class III protection
For indoor use only.
Do not dispose of waste batteries, waste electrical and
electronic equipment as unsorted municipal waste.
Waste batteries and waste electrical and electronic
equipment must be collected separately.
Waste batteries, waste accumulators, and light sources
have to be removed from the equipment.
Check with your local authority or retailer for recycling
advice and collection point.
According to local regulations, retailers may have an
obligation to take back waste batteries and waste
electrical and electronic equipment free of charge.
Your contribution to the reuse and recycling of waste
batteries and waste electrical and electronic equipment
helps to reduce the demand of raw materials.
Waste batteries, in particular containing lithium, and
waste electrical and electronic equipment contain
valuable and recyclable materials, which can adversely
impact the environment and the human health if not
disposed of in an environmentally compatible manner.
Delete personal data from waste equipment, if any.
V
Voltage
Direct current
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.

Techtronic Industries Australia Pty Ltd
31 Gilby Road, Mount Waverley,
VIC, 3149, Australia
Techtronic Industries N.Z. Limited
Unit C, 70 Business Parade South,
Highbrook, Auckland 2013, New Zealand
www.aegpowertools.com.au
www.aegpowertools.co.nz
AEG is a registered trade mark used under
license from AB Electrolux (publ).
961030024-01B