Ae-man-851-0.0 v1.0 3AGUILERA ELECTRONICA
INSTALLATION GUIDE AE/SA-C1
TABLE OF CONTENTS
PAGE
1INTRODUCTION.......................................................................................................5
1.1 AIM OF THE GUIDE............................................................................................................5
1.2 OBSERVATIONS...............................................................................................................5
1.3 WARNINGS AND PRECAUTIONS..........................................................................................5
1.4 APPROVALS.....................................................................................................................5
2CONTENTS. MATERIAL INCLUDED IN THE PACK................................................7
2.1 CHECKING THE PANEL......................................................................................................7
2.2 MATERIAL........................................................................................................................7
3INSTALLATION.........................................................................................................9
3.1 PANEL LOCATION.............................................................................................................9
3.1.1 Dimensions and attachment points..........................................................................9
3.1.2 Cabinet attachement..............................................................................................11
3.1.3 Removal of the base plate.....................................................................................13
3.1.4 Removal of the power source................................................................................13
3.2 PARTS OF THE PANEL.....................................................................................................13
3.2.1 Front plate.............................................................................................................13
3.2.2 Base plate. ............................................................................................................13
3.2.3 Power source. .......................................................................................................13
3.2.4 Backup batteries....................................................................................................13
3.3 CONNECTIONS TO EXTERNAL CIRCUITS. ..........................................................................14
3.3.1 230V mains power.................................................................................................14
3.3.2 Batteries................................................................................................................16
3.3.3 24V Auxiliary power output....................................................................................17
3.3.4 remote Disconnection............................................................................................18
3.3.5 Evacuation sounder...............................................................................................18
3.3.6 General relays.......................................................................................................19
3.3.7 Day/night modes....................................................................................................20
3.3.8 Detection loops......................................................................................................20
3.3.9 RS-232 and RS-485 Communication ports............................................................21
3.3.10 AE2NET network cabling....................................................................................22
3.3.11 End of line resistors on the AE2NET network.....................................................22
3.3.12 Earth fault monitoring. ........................................................................................22
4RECOMMENDATIONS...........................................................................................23
5PUTTING THE PANEL INTO SERVICE..................................................................25
5.1 CPU MICROSWITCH CONFIGURATION. .............................................................................25
5.2 STARTING UP THE FACILITY.............................................................................................27
5.2.1 lenguaje.................................................................................................................28
5.2.2 Led test. ................................................................................................................28
5.2.3 Clock setup............................................................................................................28
5.2.4 Startup mode.........................................................................................................29
