Aicok KE8026-UL User manual

ELECTRONIC GLASS KETTLE
INSTRUCTION MANUAL
KE8026-UL

1
KETTLE
INSTRUCTION MANUAL
MODEL: KE8026-UL
Read this booklet thoroughly before using and save it for future reference.

2
IMPORTANT SAFEGUARDS
1. Readall instructions before using.
When using electrical appliances, basic safety precautions
should always be followed, including the following:
2. Before connecting the kettle to the power supply, check that
the voltage indicated on the appliance (underside the kettle &
base) corresponds with the voltage in yourhome. If this is not
the case, contact your dealer and do not use the kettle.
3. The attached base can not be used for other than intended
use.
4. Do not operate the appliance without load to avoid damaging
the heat elements.
5. Unplug from the outlet when not in use.
6. Do not let the cord hang over edge of table counter or touch
hot surface.
7. Do not place on or near a hot gas or electric burner or in a
heated oven.
8. Should you accidentally allow the kettle to operate without
water, the boil-dry protection will automatically switch it off. If
this should occur, allow the kettle to cool before filling with
cold water and re-boiling.
9. Ensure that kettle is used on a firm and flat surface where the
children can’t touch, this canprevent from overturning the
kettle to damage the person or kettle.
10. To protect against a fire, electric shock or personal injury,
do not immerse cord, electric plugs or kettle in water or other
liquids.
11. Always take care to pour boiling water slowly and
carefully without tipping the kettle too fast.
12. Be careful when opening the lid for refilling when the
kettle is hot.

3
13. Close supervision is necessary when any appliance is used
by or near children.
14. Do not touch the hot surface. Use the handle or the button.
15. Extreme caution must be used when moving an appliance
containing hot water.
16. The appliance is not a toy. Do not let the children play it.
17. The use of attachments that are not recommended by the
appliance manufacturer may result in fire, electric shock or
personal injury.
18. While boiling water, avoid to contacting steam from the
spout when water is boiling or just after it has switched off. Do
not be anxious to uncover the lid.
19. Unplug from outlet when not in use and before cleaning;
Allow it to cool before putting on or taking off parts and before
cleaning the appliance.
20. Always ensure the lid is closed and do not lift it while the
water is boiling. Scalding may occur if the lid is removed
during the brewing cycles.
21. Do not use the appliance for other than intended use.
22. Do not move the unit while the kettle is switched on.
23The kettle can only use with the stand provided.
24. If the kettle is overfilled, boiling water may be ejected.
25. Do not use the kettle outdoors.
26. Children should be supervised to ensure that they do not
play with the appliance.
2. To Disconnect,turn any control to “off”,then remove
plug from wall outlet.

4
2. Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions,or has been
damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair or
adjustment.
.Household use only.
Short cord instruction:
Notes for cord plug:
This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit into a polarized outlet only one way, If the
plug does not fit fully into the outlet, reverse the plug, If it
still does not fit, contact a qualified electrician, Do not attempt
to modify the plug in any way.
a) A short power-supply cord is provided to reduce risks
resulting from becoming entangled in or tripping over a
longer cord.
b) extension cords are available and may be used if care
is exercised in their use.
c) If a extension cord is used:
1) The marked electrical rating of the extension cord should
be at least as great as the electrical rating of the appliance;
2) The longer cord should be arranged so that it will not
drape over the counter top or table top where it can be pulled
on by children or tripped over.
SAVE THESE INSTRUCTIONS

5
Know your kettle
Before initial use
If you are using the kettle for the first time, it is recommended that you clean your kettle before
use by boiling a full kettle of water twice and then discarding the water.
Operation
1. To fill water into the kettle, remove it from the power base and open the lid by press down
the lid button, fill with the desired amount of water to the kettle. Always fill the kettle between
the minimum (0.5L) and maximum (1.7L) marks. Too little water will result in the kettle
switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout
when boiling. Ensure that the lid is firmly in place before connecting the power cord to
the outlet.
Lid handle
Housing
Bottom cover
Base
Switch
Handle
Handle cover
Lid

6
2. Close the lid. Position the kettle on the power base in place. Make sure the kettle contact with
the power base completely.
3. Connect the plug into a power outlet. Lift the switch upwards to “I” position and the switch
light illuminates. Then start to boil the water. The kettle will switch off automatically once the
water has boiled and the switch light extinguishes. You can shut off the power by pressing the
switch at any moment during boiling water.
NOTE：Ensure that switch is clear of obstructions and the lid is firmly closed. The kettle
will not turn off if the switch is constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water may
result in scald, besides, don’t open the lid while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is uplifted. Allow to cool for 15~20 seconds before
reopening to boil water. The kettle may be stored on the power base when not in use.
NOTE：Ensure power supply is turned off when kettle is not in use.
Boil-dry protection
Should you accidentally allow the kettle to operate without water, the boil-dry protection will
automatically switch it off. If this should occur, allow the kettle to cool before filling with cold
water and re-boiling.
Care and cleaning
Always disconnect the appliance from the power outlet and leave it to cool down completely
before cleaning.
Never immerse the kettle or cord in water, or allow moisture to contact with these parts.
Any other servicing should be performed by an authorized service representative.
Removal of mineral deposits
Mineral deposits in tap water may cause the kettle interior to discolor .To remove this build-up,
use non-toxic Liquid Descaler.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar and the remainder of water and be allowed to
stand overnight. Do not boil.
2. Empty the solution from the kettle. Any stains remaining inside the spout can be removed by
rubbing with a damp cloth, fill the kettle with clean water, bring to boil and then discard the
water. Repeat and the kettle will then be ready to use.
Cleaning external housing
Wipe the external housing with a wild and damp cloth or cleaner.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of
the kettle.

7
Cleaning the filter
Remember to clean the filter with a wild and damp cloth at intervals.
Storage
When not in use or storage, the power cord may be wound around the cord storage under the
base of kettle.
Environment friendly disposal
You can help protect the environment!
Please remember to respect the local regulations:
hand in the non-working electrical equipments to
an appropriate waste disposal center.