02
Website:www.aiks.com.hk
1 installation should check the rating plate, mark the basic technical data on the compliance requirements.
2 Check the circuit breaker and manual several times, action should be flexible, to confirm intact, in order to install.
3 Breakers should be installed vertically, so that the handle at the bottom, moving the handle up position contact closed
position.
1. To close the circuit breaker, shall handle push up toward the direction of the arrow 0N.
2 circuit breaker overload, short circuit protection features are factory setting, not at liberty to use open regulation.
3 The circuit breaker enclosure is IP20 grade, do not use protection levels that do not meet the requirements of thisplace
1 circuit breaker in the transport, storage and use, are not affected by rain and snow
2 circuit breaker in operation should be checked regularly to check working conditions as determined by periodic check
should be cut off the power to avoid causing short circuits.
