Ailebebe SARATTO User manual

SARATTO INSTRUCTION
Acceptable weight and height
Acceptable weight: 9 kgs through 18 kgs
Acceptable height: 75 cm through 100 cm
Age for reference: 1 through 4 year-old
Note: Install Impact Shield without failure
Acceptable weight: 15 kgs through 25 kgs
Acceptable height: 100 cm through 120 cm
Age for reference: 3 through 7 year-old
Acceptable weight: 15 kgs through 36 kgs
Acceptable height: 100 cm through 145 cm
Age for reference: 3 through 11 year-old
Verify that following components are involved.
Part names
Part names of a car
Booster Seat
Impact Shield
Backrest
Headrest
Belt-guide
Belt conduit
Shoulder belt conduit
Waist belt conduit
Keep the manual in the
pocket on the back
Pocket
Backrest
Shoulder seat belt
Buckle
Seat
Waist seat best

How to assemble
1. Joint booster seat and backrest together as shown in Fig.
2. Lift a backrest to upright position as shown in Fig.
3. Insert headrest into guide holes on backrest and depress it until it clicks.
4. Put a flap of seating surface into backrest as shown in Fig.
How to detach
1. Recline backrest until it comes flat.
2. Lift backrest up to detach it from seating surface.
Flap

How to use child safety seat with impact shield
1.
2.
3.
4. Pull shoulder seat belt to remove slack of waist seat belt.
5. Thread shoulder seat belt through seat belt conduit.
Place child safety seat on a car’s seat facing forward. Backrest of the product
should contact car’s backrest as close as possible.
Sit a child on a safety seat with its spine pressed against backrest. Install
Impact Shield as it contacts with chest of child, and fix it by flaps right and left
Thread waist seat belt through seat belt conduit and buckle up for sure as
shown in Fig.
Impact Shield
Flap
Buckle
Shoulder seat
Waist seal

How to use child safety seat without impact shield
1.
2.
3.
4.
5. Pass safety belt through conduit.
Place child safety seat on a car’s seat facing forward. Backrest of the product
should contact car’s backrest as close as possible.
Sit a child on a safety seat deep in a seat. Buckle up safety seat belt for sure.
Adjust height of headrest so that shoulder seat belt comes just above
shoulder.
Pass waist seat belt and shoulder seat belt throught conduit as shown in
Fig. Child should be restrained by pelvis. Verify that safety best comes on
Conduit
Shoulder seat
Conduit
Conduit
Remove slack of safety

How to use booster seat
1. Place booster seat deep in on a car's seat.
2.
Verify that safety best comes on groin so that child is restrained at pelvis.
3.
4. Make sure safety bests are securely tightened.
How to remove seat cover for cleaning
1. Detach booster seat and backrest.
2. Unzip fastener on headrest and remove cover.
3.
Pass shoulder seat belt through conduit. Adjust it to come just above
shoulder.
Sit a child deep in booster seat. Pass waist seat belt through conduit and
buckle up for sure.
Cover
Fastener
Unzip fastener on backrest, undo strings and remove cover.
Fastener
String
Unhook and unscrew applied and remove cover.

4.
5. Unhook hooks inside conduit and remove cover.
Unhook
Unhook
Unhook
Unscrew
Unhook and unscrew applied and remove cover.
Conduit
Unhook