Aiphone IS-DVF-2RA-FR User manual

IS-DVF-2RA-FR
Stainless Steel Flush Mount Video Door Station with
Standard & Emergency Call Buttons
-INSTRUCTIONS-
Pg.1
The IS-DVF-2RA-FR is a stainless steel ush mount video door station with standard and emergency
call buttons. The unit is equipped with signage in French for both the standard and emergency
buttons. A call status indicator is included to meet rescue assistance requirements.
The IS-DVF-2RA-FR must connect to the IS-CCU or IS-SCU control units.
1
2
3
4
5
6
7
8
9
IS-DVF-2RA-FR NAMES & FUNCTIONS:
1. Camera 6. Call status indicator
2. Microphone 7. French Signage
3. LED Light 8. Call button
4. Speaker 9. Emergency button
5. Name Placard
FEATURES:
• Audio communication with visual indentication
of calling area
• Two call buttons: Standard and Emergency
• LED call status indicator
• CCTV input
• Red mushroom button for emergency call
• Two programmable relay outputs for activation
of external systems/devices
• Name placard
• Stainless steel faceplate with tamper resistant
screws
PACKAGE CONTENTS:
IS-DVF-2RA-FR
Vandal-resistant Door Station
Semi-ush backbox &
tamper-resistant screws
Security Driver
Blank name
placard
INSTALLATION:
• For ush mounting, cut a hole in the wall and
use supplied back box.
Box dimensions are:
10-½" H x 5-13⁄16" W x 1-¾" D
• For surface mounting, use the SBX-IDVFRA
surface mount box. This box can mount to a
standard 1-gang box or to any at surface.

Pg. 2
IS-DVF-2RA-FR Instr.
1218
WIRING DIAGRAM:
IS-DVF-2RA-FR
IS-CCU
IS-MV
IS-PU-UL
N/O Dry Contact
0.5 Amp
CAT-5e
CAT-5e
NO
COM
NC
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
• For proper regulatory compliance, the drain wire should be disconnected at the power
supply end of the cable.
• Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
SPECIFICATIONS:
Camera unit: CMOS camera
Scanning line: 525 lines
Min. illumination: 5 Lux at 1'6"
Terminations: RJ45 jack for audio/video
Screw terminals for door release and relay outputs
Relay rating: 24V AC/DC 0.5A on Door station, 24V AC/DC 1.0A on relay board
Operating Temp: 14° ~ 140°F / -10° ~ 60°C
Wiring Distance: 980' with Cat5e/6 cable
Dimensions: 11-¾" H x 7" W
w/SBX-IDVFRA: 11-13⁄16" H x 7-1⁄16" W x 3-5⁄16" D (top), 2-5⁄16" D (bottom)
OFF ON
NO
NO
C
NC
C
NC
1234
RELAY BOARD WIRING AND SETTINGS:
Relay 1 Output
N/O, COM, N/C
Relay 2 Output
N/O, COM, N/C
*Relay 2 External Reset
Connect to N/O dry switch
Conguration Switch
See Settings to right
OFF ON
NO
NO
C
NC
C
NC
1234
Board on back of unit
See wiring below
ON
1234
Default Conguration when shipped
Optional Conguration
Normal Call
Emergency Call
Talking
Door Release
Trigger Source RY1 Triggered? RY1 Remains ON
During Talking? RY2 Triggered? RY2 Remains ON During Talking?
RY2 Requires
Reset?
YES
NO N/A
YES
YES YES
YES YES NO
NO
NO
NO
N/A
N/A
N/A
N/A
N/A
N/A
YES
YES
ON
1234
Contact Technical Support if additional switch congurations
are required.
Relay 1 triggers on normal call, emergency call, and communication. Relay 1 remains on during communication.
Relay 2 triggers on emergency call and remains on during communication.
Relay 1 triggers on normal call, emergency call, and communication. Relay 1 remains on during communication.
Relay 2 triggers on an emergency call and remains on during communication. Relay 2 requires reset.
Normal Call
Emergency Call
Talking
Door Release
Trigger Source RY1 Triggered? RY1 Remains ON
During Talking? RY2 Triggered? RY2 Remains ON During Talking?
RY2 Requires
Reset?
YES
NO N/A
YES
NO N/A
N/A
N/A
YES
YES
YES
YES
YES YES
N/A
N/A
N/A
NO
NO
YES*
A
iphone Corporation
[phone]
[email protected]
www.aiphone.com