Aiphone LA-20AS User manual

- INSTRUCTIONS -
The LA-20AS and LA-40AS add-on selectors are designed to function with LAF-C Console Masters, Type "E" or
later. Multiple add-on selectors can be added to a master station along with a variety of sub stations to create a
communication system tailored to a user's needs. All standard LAF and LEF system accessories can be used in
conjunction with the add-on selectors.
LA-nAS
Add-on selectors for the LAF-C/E Console masters.
LA-20AS, 20-call LA-40AS, 40-call
Special
Order
Products
Pg. 1
NAMES & FUNCTIONS:
1. OFF button
2. Selector button
3. OFF LED
4. Directory card
5. Station selector LED
L-nAS TERMINAL DEFINITIONS:
+Positive 12V DC
-Negative
1~40 Station number
ECommon communication
Individual Components for System:
LAF-nC Console type master (20, 40 call capactiy)
LAF-nCA Console type master w/handset (20, 40 call capactiy)
LA-20AS 20-call Add-on Selector
LA-40AS 40-call Add-on Selector
PS-12C 12V DC, 1A Power Supply
BG-10C All Call, Chime and music adaptor. (1 required per 10 stations)
PS-12F 12V DC, 2.5A Power Supply (1 Required per BG-10C)
LS-NVP Vandal proof sub station (flush mount)
LS-NVP-W Weather resistant vandal proof sub station (flush mount)
SBX-NVP Surface mount box for LS-NVP and LS-NVP-W
LE-series Any model sub station with LE- prefix
12
54
3
SPECIFICATIONS:
Power Source: 12V DC at master. Use PS-12C, or PS-12F when BG-10C(s) are included (1 PS-12F per BG-10C)
Communication Output:800mW at 20 ohms (receive); 500mW at 20 ohms (transmit)
Communication: Push-to-talk, release-to-listen (TALK button), or VOX handset at master. Hands free at sub station.
Calling: Master to sub or other master: By voice (TALK) or tone (TALK & ALL CALL simultaneously)
Sub to master: Call button on sub activates tone and LED at master, remaining lit for approximately
20 seconds.
Wiring: 2 conductors homerun to sub station (1-Master system only), 3-conductor, or loop multi-conductor
with 2 common + 1 individual wire per sub station on wire run.
Shielded cable is recommended.
Use Aiphone #822202, 2 cond. 22AWG; #821802, 2 cond. 18AWG or #822203, 3 cond. 22AWG;
#822206, 6 cond. 22AWG. LA-nAS to ea. BG-10C: Aiphone #822220, 20 cond. 22AWG.
Wiring Distance: 650' with 22AWG; 1,600' with 18AWG.
Dimensions: LA-20AS: 10-1/4" x 7" x 5-1/2".
(H x W x D) LA-40AS: 10-1/4" x 12-7/8" x 5-1/2".

Pg. 2
LA-20,40AS Instr.
1098mkjd
TOLL FREE TECHNICAL SUPPORT:
[phone]
TOLL FREE FAX LINE:
[phone]
TECHNICAL SUPPORT E-MAIL:
[email protected]
WIRING DIAGRAM:
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
[phone]
FAX [phone]
CAUTION
* Do not connect any AC wires to any terminal on any unit, as fire or unit damage may occur. Connect only
specified power source on +, - terminals.
* Do not install more or different power sources than specified for the system.
* Do not attempt to install or connect wires on LAF-C system while the system's power supply is plugged in.
* L-nAS add-on selectors and related equipment, unless specified as "weather resistant", are designed for indoor
use only.Door stations (LE-D, LE-DA, LE-DL, LS-NVP-W) may be installed outdoors.
IMPORTANT
* There is no need to disassemble the equipment for installation. Do not access the PC boards inside the units
unless
properly qualified.
* Any other manufacturer's products installed with the system (power supply, external signalling device, etc.) are
not covered under Aiphone's warranty.
* Do not mount L-nAS equipment in the following places, as it may cause the system to malfunction:
- High or extreme cold temperature areas: under direct sunlight, near equipment that varies in temperature,
in front of air conditioner, inside a refrigerated area, etc.
- Places subject to moisture or humidity extremes.
- Places subject to environmental conditions, such as dust, oil, chemicals, salt, etc.
* L-nAS units are electronic devices, which must not be subjected to water or any other liquid.
* Severe weather conditions, such as lightning storms, may cause damage to LAF-C equipment. We recommend
that power surge protection be installed to minimize potential component level damage.
- Additional SA-1 surge arrestors should be installed on all communication lines (one SA-1 for every two
wires connected to master.) See SA-1 instructions for further information.
For additional information about this system,
please refer to the LAF-C instructions.
1
2
3
~
20
E
-
R
X1
X2
X3
X4
X5
X6
X7
X8
+
-
LAF-20CA
+
-
PS-12C
LE-D
1
E
-
LE-D LE-D
1
E
-
1
E
-
LA-40AS
1
2
3
~
40
WIRING NOTE:
The following sub stations
are wired as shown above:
· LE-A, LE-AN
· LE-B, LE-BN
· LE-D, LE-DA
Blk
Yel
Org
Gry
Brn
Red
Wht
Grn
Wiring from
Add-on Selector
LE-DA
1
E
-
LE-DA
1
E
-
NOTE:
LA-20AS wires
the same as
shown here.