AIR GAP AG110-002 User manual

REVERSE OSMOSIS
AIR GAP
Model:
Old Part Number:
500 Jefferson Street, Placentia, California 92870 USA • 949-955-3928 • Email: [email protected]
Copyright AIR GAP INTERNATIONAL
Placentia, California
AG110-002
GAP-A-RO, KIT S-B
Doc.#400-0807-001
5. Connect 3/8" OD poly tubing from
your RO unit to AG110-002 inlet port
and 3/8" OD poly tubing from the
AG110-002 outlet port to the drain
pipe. Use provided clamps and
screws to secure tubing. (See FIG
1-5)
4. The AG110-002 must be installed with the "C/L" line
above the sink's rim, sump, floor drain, floor grate, or
standpipe where the discharge tubing is terminated. The
AG110-002must be installed vertically. Secure
AG110-002 with provided mounting screws (See Fig 1-4).
"C/L"
0.857"-0.900"
Critical Level (C/L) marking
Mounting Screws
Fig 1-4
Fig 1-5
3/8” O.D.
Poly tubing
Clamp
1/4” O.D.
Poly tubing

Installation Procedures
LIST OF PARTS ENCLOSED
-OVER-
AG110-002
1- Reverse Osmosis Air Gap
1- Mounting Bracket
4- 3/8 Nylon Clamp
6- #6-1", Phillips Pan Head Screws
-OVER-
Inlet Port
Outlet Port
Mounting Bracket
Reverse Osmosis
Air Gap Drain
1.14"
3.7"
Water supply
Water Cooler
RO System
Discharge
Drain Pipe
AG110-002
RO Tank
Please read the instructions once through before starting.
AG110-002 INSTALLATION INSTRUCTION
Always comply with local plumbing codes during installation
Mounting option 1 Mounting option 2
Fig 1-1 Fig 1-2
Inlet Marking
Outlet
Marking
Inlet Port
Outlet Port
Reverse Osmosis
Air Gap Drain
Inlet Marking
Outlet
Marking
Mounting Bracket
Fig 1-3
1"
1. Make sure that the flow rate output of the RO equipment meets AG110-002 flow capacity limits such
as 0.4 GPM (1.5 Liters/minute).
2. Check inlet and outlet ports marking on AG110-002 body and install AG110-002 into the threaded opening of the
mounting bracket as shown on FIG 1-1 (mounting options 1 and 2), for dimensions see FIG 1-2.
3. AG110-002 is a gravity flow device and must have an
outlet poly tubing feeding directly to a drain without kinks
or bends. The AG110-002 must be permanently
connected to enable the discharge water to flow freely
through the outlet tubing. (See FIG 1-3)
Inline Reverse Osmosis
air gap
The AG110-002 Reverse Osmosis Filter Air Gap prevents back-flow from the discharge line into
the RO system. The discharge water flows out of the reverse osmosis system into the air gap
inlet, passes air-gap, and then down to the drain piping.
• Secure connection of inlet and outlet ports.
• Tested for maximum 0.4 GPM (1.5 Liters/minute)
• Suggested flow rate 1 to 16 oz/minute (30 to 500 milliliters/minute)
• UPC® listed, tested for compliance with IPC and NSF standards